SIIG CEMT0A12S1 - Manual
SIIG CEMT0A12S1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step 1: Wall Plate Installation; Wood Stud Installation
- Page 3 – Step 3: Final Installation
- Page 4 – Maintenance; Check the mounting screws every two months for tightness.
- Page 5 – Blank Page
- Page 7 – Technical Support and Warranty
- Page 8 – Product Name
A
B
C
D
E
F
G
(x2) M6X60
bolt
(x2) M6 concrete
anchor
(x4) M6 small
washer
(x2) M6 large
washer
(x4) M4X12
screw
(x4) M5X12
screw
(x4) M6X12
screw
4mm Allen Key
6mm Allen Key
04-0553C
LCD TV/Monitor Tilting Mount - 10" to 26"
Hardware
Installation Instructions
Tools Required
: Electronic stud finder, #2 Phillips head screw driver, drill, 1/8" drill bit (wood
stud installation), 3/8" masonry drill bit (concrete/brick wall installation).
Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 2 3 4 Figure 1 Figure 2 1 2 3 Step 1: Wall Plate Installation Hold the wall plate (Figure 2) to the wall, use the two mounting holes to mark thelocations to be used for mounting the wall plate. Locate the holes directly into thebrick, block or concrete, never into the mortar between the blocks.Pre...
1 2 Figure 3 1 2 3 Figure 4 Phillips screw driver Figure 5 Figure 6 Figure 7 Step 3: Final Installation Step 2: Display Plate Installation Hang the display plate onto the top of thewall plate and slip it into the wall plate asshown (Figure 4).Tighten the safety screw on the side andback using a Phil...
Important: If you don't understand the installation instructions, please consult an installation specialist. Maintenance Check the mounting screws every two months for tightness. Page 4
