SIIG 2S - Manual
SIIG 2S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Package Contents; CyberPro PCI 2S; Layout
- Page 3 – Hardware Installation
- Page 4 – Driver Installation; CyberPro PCI
- Page 5 – Windows ME
- Page 6 – To Verify Windows NT 4.0 Installation
- Page 9 – Changing COM Port Address
- Page 10 – Blank Page
- Page 11 – Technical Support and Warranty; Online Support
- Page 12 – networking, sound cards, and other accessories. SIIG is the premier
1
CyberPro PCI 2S
Quick Installation Guide
0 4 - 0 3 4 2 C
Introducing the CyberPro PCI 2S
The
CyberPro PCI 2S
high-speed serial I/O card provides
two additional 9-pin serial ports. Depending on the
model purchased, this board will fit into either a
Full
or
Low Profile
chassis.
Features and Benefits
•
Conforms to PCI v2.2 Plug and Play
•
Full support for Windows-based software
•
R e d u c e s C P U l o a d a n d i m p r o v e s s y s t e m
performance dramatically
•
IRQ sharing feature reduces IRQ conflicts
•
High-speed serial port (9-pin) works with 56K V.90
external modems, ISDN terminal adapters, PDAs,
digital cameras, label printers and other serial port
devices
•
Built-in FIFO buffers dramatically increase data
transmit/receive speed, especially under Windows'
multitasking environment
•
Each serial port can be configured for either 5V or
12V output, for serial devices that require power
System Requirements
•
Pentium or equivalent computer with an available
PCI slot
•
Windows
®
95/98/98SE/ME/NT 4.0/2000/XP (32-
/64-bit)/Server 2003 (32-/64-bit)/Vista (32-/64-bit)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Package Contents • CyberPro PCI 2S board • 2-port fan-out cable • Low profile bracket (Dual Profile board only) • Driver CD • Quick installation guide Layout Figure 1. Layout * Note: Depending on the model purchased, the bracket size will be either Full or Low profile. Jumper Settings (JP1, JP2) O...
3 Fan-out Cable 25-pin connector 9-pin serial 9-pin serial Figure 2. Fan-out cable Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if ne...
4 5. Set JP1 and JP2 jumper settings to the desired voltage only if your serial device needs additional power from the serial port. However, most serial devices do not require additional power. For more information see Figure 1 on page 2 . The jumpers can be removed if power is not required. 6. To i...
