SIIG 04-0288E - Manual
SIIG 04-0288E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – System Requirements; Recommended system for DV capturing editing:; Package Contents
- Page 3 – Board Layout; optional
- Page 4 – Add New Hardware
- Page 5 – Windows ME
- Page 7 – To Verify Successful Driver Installation
- Page 8 – or
- Page 9 – Ulead VideoStudio Software Installation; Connecting DV Camcorder
- Page 10 – To Verify Successful DV Camcorder Setup
- Page 11 – Technical Support and Warranty; O n l i n e S u p p o r t
- Page 12 – Networking, Sound Cards, and other accessories. SIIG is the premier
1
USB 2.0+1394 DV Kit
Quick Installation Guide
04-0288E
Introducing the
USB 2.0+1394 DV Kit
The
USB 2.0+1394 DV Kit
is a complete DV editing kit --
a combo card with USB 2.0 and FireWire (1394a) interfaces,
deluxe DV editing software (full DV, AVI, QuickTime,
Windows Media, RealNetworks, and MPEG2 support)
and a 1394 6-pin/4-pin DV cable.
Features and Benefits
•
Combo card design adds four USB 2.0 (480 Mbps)
and three 1394a (400 Mbps) ports into your system.
•
Hot-swapping feature allows you to connect/
disconnect devices without first turning your system
off
USB 2.0 interface
•
Adds three external and one internal USB 2.0 ports
•
Compliant with USB specification rev. 2.0
•
Supports high-speed (480 Mbps), full-speed (12
Mbps), and low-speed (1.5 Mbps) data transfer
modes for simultaneous operation of multiple USB
2.0/1.1 devices
Note:
USB 1.1 devices are limited to USB 1.1 speeds
even when they are connected to USB 2.0 host adapter
or USB 2.0 hubs.
FireWire (1394a) interface
•
Adds two external and one internal FireWire ports
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 • IEEE 1394-1995, P1394a (rev. 1.1) and OHCI Interface Specification 1.0 compliant • Supports serial bus data transfer rates of 100, 200 and 400 Mbps System Requirements • Pentium or equivalent computer with an available PCI slot • Windows 98SE/ME • Windows 2000 (with SP 3) or later • Windows XP (...
3 Board Layout Figure 1. Board Layout Power Connector (optional) USB 2.0 Port USB 2.0 Ports 1394 Ports 1394 Port Note: This power connector (same as the one used with your floppy disk drive) is designed to provide additional power to the board when needed. This connection is optional . We recommend ...
4 Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed.Static Electricity Discharge may permanently damage your system. Discharge a...
