Hilti 3578886 - User Manual

Page 4 - Safety

2 English 1.3 Product-dependent symbols1.3.1 Symbols on the product The following symbols are used on the product: Wear eye protection.Revolutions per minuteRevolutions per minuteRated speedDiameterProtection class II (double-insulated) 1.4 Product information Hilti products are designed for profess...

Page 11 - Electrical safety; Do not use cutting discs for grinding.

English 9 ▶ Before starting work, check the hazard class of the dust that will be pro- duced when working. Use an industrial vacuum cleaner with an officially approved protection class in compliance with the locally applicable dust protection regulations. Dust from materials such as lead-based paint...

Page 12 - Description

10 English 3 Description 3.1 Product overview Printed: 12.09.2017 | Doc-Nr: PUB / 5373332 / 000 / 02

Page 14 - Front cover for the disc guard; wheels for grinding mineral materials.; CAUTION; Use of this hood for working on metal is prohibited.

12 English 3.6 Front cover for the disc guard When grinding with straight grinding discs and cutting with cutting discs in metalworking applications, use the standard guard with front cover. 3.7 DG-EX 115/4,5" dust hood for grinding (accessory) The grinding system is suitable only for occasional...

Page 17 - Operation

English 15 shown on the type identification plate of the device. The operating voltage of the transformer or generator must always be within +5% and -15% of the rated voltage of the device. AG 500-7SE Rated power input 780 W Rated speed 11,500 /min Maximum disc diameter 125 mm Maximum disc diameter ...

Page 18 - Note

16 English 1. Release the clamping lever. 2. Fit the guard onto the spindle collar so that the keyed locating lug engages in the recess provided. 3. Rotate the guard to the required position. 4. Secure the guard by closing the clamping lever. Note The guard is already set to the correct tension by w...

Page 23 - Care and maintenance

English 21 6.10 Cutting ▶ When cutting, apply moderate feed pressure and do not tilt the power tool or the cutting disc (when working, hold at approx. 90° to the surface being cut). Note For best results when cutting profiles and square tube, start cutting at the smallest cross section. 6.11 Rough g...

Page 27 - Replacing the carbon brushes; Disconnect the supply cord plug from the power outlet.

English 25 7.4 Replacing the carbon brushes 1. Disconnect the supply cord plug from the power outlet. 2. Unscrew the screw in the rear part of the housing and remove the rear part of the housing. 3. Use pliers to slide the spring plate to the side. 4. Remove the carbon brush with your fingers or wit...

Hilti 3578886 - User Manual

Table of Contents:

Summary

Other Hilti Angle Grinders Models