Franke FFP S700 - Manual - manualsarea.com

Page 3 - Faucet installation; Please remove all components from package and inspect prior to; Remove all mounting hardware from protecting plastic bag.

3 ENGLISH Faucet installation Please remove all components from package and inspect prior to installation (see itemized table and picture). NOTE: Call us immediately if you see inconsistencies. (1-800-626-5771) or visit www.frankeksd.com TABLE OF CONTENTS 1 Faucet 2 Fastening set (rubber washer, tri...

Page 4 - Set the faucet into place on the sink as indicated in the figure.; Install faucet to the sink or countertop

4 ENGLISH Set the faucet into place on the sink as indicated in the figure. NOTE: the rubber O-ring should be sitting on top of the countertop and between the faucet body. DO NOT use putty or other sealant at this location. Install faucet to the sink or countertop

Page 5 - Install faucet to the sink or

5 ENGLISH Install faucet to the sink or countertop - follows Install the fastening components to the faucet’s threaded shank in the following sequence: O-ring (1), triangular flange (2), metal washer (3) and threaded nut (4) (the triangular flange can be omitted if the sink/countertop is too thick)....

Page 6 - Attach the valve-holder to the shorter tubing and attach the spray; Attach the valve-holder

6 ENGLISH Attach the valve-holder to the shorter tubing and attach the spray hose to the valve-holder. NOTE: The provided small black rubber washer needs to be installed here. DO NOT use putty or other sealant agents at this joint. Attach the valve-holder 20 mm [13/16”] key

Page 7 - Connect the supply line; open end towards the sink drain.

7 ENGLISH Connect the supply line Connect the supply line. In order to guarantee a long use of the pro - duct, install the angle valve equipped with filter and clean them regu - larly. Do not allow the supply tube to twist or bend sharply. Flush out debris from water lines and faucet. 1. Pull spray ...

Page 8 - Assemble Pull-out Spray; Attach the pull-out spray head to the hose.

8 ENGLISH Assemble Pull-out Spray Attach the pull-out spray head to the hose. NOTE: The rubber washer needs to be installed to prevent leakage. Fasten the weight to the hose as shown in picture below. Test all water lines, fitting and connections for leaks.

Page 9 - Replacing the cartridge; loosen the set screw (A) which is accessible from the back of the han

9 ENGLISH Replacing the cartridge Before starting, shut off the water supply to the faucet and move the faucet handle to the off position. Use a 2.5mm [1/8”] Allen key to loosen the set screw (A) which is accessible from the back of the han - dle. Lift the handle (B) from the cartridge (F). Find the...

Page 10 - General maintenance; Do not use harsh detergents, solvents, chemical agents, metallic

10 ENGLISH General maintenance Do not use harsh detergents, solvents, chemical agents, metallic sponges, etc. that could harm the surface. Clean only with a soft sponge and soapy water. Clean and then dry properly the faucet in case of very hard or calcare - ous water, whose deposits cold damage the...

Page 11 - Limited lifetime warranty

11 ENGLISH Limited lifetime warranty Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the origi - nal purchaser of its faucets effective January 1, 2003. All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical pa...

Franke FFP S700 - Manual

Table of Contents:

Summary

Other Franke Models