Chicago Electric 90186 - Manual
Chicago Electric 90186 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – READ AND UNDERSTAND ALL INSTRUCTIONS; WORK AREA; Keep your work area clean and well lit.; Cluttered benches and dark areas; Do not operate power tools in explosive atmospheres, such as in the; Power tools create sparks
- Page 5 – SPECIFIC SAFETY RULES
- Page 7 – this product, but must be supplied the the operator.; outlet installed by a qualified electrician.
- Page 8 – FIGURE A; to an electrically “live” terminal.; DOUBLE INSULATED TOOLS: TOOLS WITH TWO PRONG PLUGS; Canadian Standard Association, and the National Electrical Code.; FIGURE B
- Page 9 – EXTENSION CORDS; can use either a two or three wire extension cord.; FIGURE C
- Page 10 – SYMBOLOGY; UNPACKING; Parts List on page 17; ASSEMBLY INSTRUCTIONS; Assembly Diagram; prior; NOTE: Make sure to install the new Saw Blade with its
- Page 11 – place by tightening; FIGURE D
- Page 12 – OPERATING INSTRUCTIONS; , Shell Tivela Oil s680; plugged from its electrical outlet; FIGURE H
- Page 13 – FIGURE I; Proper Operation During The Sawing Process:
- Page 14 – Make sure the Power Switch (part #67) of the Circular Saw is in its; “OFF”; inspect the general condition of the Circular Saw. Check; Do not use damaged equipment.; run the Saw in its continuous mode.
- Page 15 – FIGURE J; To maintain peak efficiency of the Circular Saw’s Motor it; FIGURE K
- Page 16 – PLEASE READ THE FOLLOWING CAREFULLY; The ventilation openings should be kept clean and free of dirt and
- Page 17 – PARTS LIST
- Page 18 – LIMITED 90 DAY WARRANTY; which vary from state to state.
- Page 19 – DIAGRAM
7-1/4” CIRCULAR SAW
WORM GEAR DRIVE
Model
90186
ASSEMBLY AnD OpERAtInG InStRUCtIOnS
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE thIS MAnUAL.
Copyright
©
2008 by Harbor Freight Tools
®
. All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the express written consent of Harbor
Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improve-
ments, actual product may differ slightly from the product described herein. Tools required for assembly
and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Revised Manual 10i
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PRODUCT SPECIFICATIONS SAVE THIS MANUAL You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front co...
22. Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools. 23. Use only accessories that are recommended by the manufact...
18. Always turn off the Circular Saw and unplug it from its electrical outlet before changing accessories or performing any inspection, maintenance, or cleaning procedures. 19. The warnings and cautions discussed in this manual cannot cover all possible conditions and situations that may occur. It m...
