Neff I71F57N0 - Manuals

5 Intended use This extractor hood complies with the stipulated safety regulations. Improper usemay result in injury or damage. The extractor hood may be used in the household only. The manufacturer is not liablefor damage which is caused by improper use orincorrect operation. The manufacturer canno...

6 Safe operation is possible provided the low pressure in the installation room of the heatingappliance does not exceed 4Pa (0.04mbar).This can be achieved if the combustion air canflow through non-closable openings, e.g. indoors, windows, in conjunction with airintake/exhaust air wall boxes or by o...

7 Safety instructions Proper use Clean the extractor hood thoroughly before using for the first time. Before cleaning and servicing the extractor hood, isolate it from the power supply bypulling out the mains plug or switching off thefuse. Bulbs (especially halogen bulbs) become very hot during oper...

8 Operating modes An activated carbon filter must be installed tobind odours in circulating-air mode (see”Removing and installing the grease filters”).The complete installation set as well as thereplacement filters are available from specialistoutlets, customer service or the Online Shop.The accesso...

9 Operation Light Fan On/Off Switch back fan Display fan settings Fan run-on Switch on and increase fanIntensive setting Grease filter saturation display NOTE: It is recommended to switch on the blower when you start cooking and not toswitch it off again until several minutes after youhave finished ...

10 Cleaning and care L OOKING AFTER THE APPLIANCE Suitable cleaning agents and care products for your appliance can be purchased via theHotline or from the Online Shop (see coverpage). Appliance surfaces NOTE: Observe the warranty regulations in the enclosed service booklet. The appliance surfaces a...

11 Removing and installing the grease filters Activated carbon filters bind the odours in circulating-air mode. Installing and removing the activatedcarbon filters 1. Remove the grease filters (see Removingand installing the metal-mesh grease filters). 2. Insert the activated carbon filter. 3. Lock ...

12 Changing the bulbs Changing the halogen bulbs Halogen bulbs become very hot duringoperation. Even some time after the appliancehas been switched off, there is still a risk ofburns! Before changing the halogen bulbs, ensure that they have cooled down fully. 1. Press on the inner frame of the halog...

13 Prior to installation, always follow the instructions and warnings in the chapterentitled ”Safety instructions”! Exhaust-air mode The exhaust air is conveyed upwards via a ventilation shaft or directly through the outerwall to the exterior. NOTE: The exhaust air must not be conveyed into a functi...

15 Installation The extractor hood is designed for installation on the kitchen ceiling or on a rigidsuspended ceiling. During installation, optional accessories may also require fitting. Observe the minimum distance between hob and extractor hood (see ”Safetyinstructions”)! Avoid damaging the sensit...

16 Installation Installing the lower support frame Attach upper and lower parts of the support frame at the specified total heightwith 10 screws (preferred hole selection, seediagram). Ensure that the lower support frame is in the correct position. The open side must befacing the hob control. NOTE: ...

17 4. Push up the upper flue part and secure with2 screws. 5. Insert the two lower parts of the flue andpush together. Installing the flue ducts RISK OF INJURY The insides of the flue ducts may have sharpedges. We recommend wearing protectivegloves during installation. 1. Separate the flue ducts. To...