Page 4 - C Agency Regulatory Notices
Contents User’s Guide www.hp.com iv C Agency Regulatory Notices Federal Communications Commission Notice. . . . . . . . . C–1 Modifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C–2Cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C–2 Declaration ...
Page 5 - Product Features
User’s Guide www.hp.com 1–1 1 Product Features The Flat Panel Monitor L2035 has an active matrix, thin-film transistor (TFT), liquid crystal display (LCD). The monitor features include: ■ Large 20.1-inch (51 cm) viewable area display. ■ 1600 × 1200 resolution, plus full-screen support for lower reso...
Page 7 - Safety and Maintenance; Important Safety Information
User’s Guide www.hp.com 2–1 2 Safety and Maintenance Guidelines Important Safety Information A power cord is included with your monitor. If another cord is used, use only a power source and connection appropriate for this monitor. For information on the correct power cord set to use with your monito...
Page 8 - Maintenance Guidelines
2–2 www.hp.com User’s Guide Safety and Maintenance Guidelines Ä CAUTION: For the protection of your monitor, as well as your computer, connect all power cords for your computer and its peripheral devices (such as a monitor, printer, scanner) to some form of surge protection device such as a power st...
Page 10 - Cleaning the Monitor; Shipping the Monitor
2–4 www.hp.com User’s Guide Safety and Maintenance Guidelines Cleaning the Monitor To clean the monitor, follow these steps: 1. Turn off the monitor and the computer. 2. Dust the monitor by wiping the screen and the cabinet with a soft, clean cloth. If the screen requires additional cleaning, use a ...
Page 11 - Setting Up the Monitor
User’s Guide www.hp.com 3–1 3 Setting Up the Monitor To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow these steps: 1. Place the monitor in a convenient, well-ventilated location near your computer. 2. Connect one end ...
Page 16 - Removing the Monitor Base
3–6 www.hp.com User’s Guide Setting Up the Monitor Removing the Monitor Base You can remove the monitor base to mount the monitor on a wall, swing arm, or other mounting fixture. Read the caution and warning statements below before beginning the procedure. Ä CAUTION: Before beginning to disassemble ...
Page 18 - Mounting the Monitor
3–8 www.hp.com User’s Guide Setting Up the Monitor Mounting the Monitor 1. Remove the monitor base. Refer to “Removing the Monitor Base” steps in the previous section. When the base is removed, four threaded mounting holes are exposed on the monitor panel to be used for mounting purposes. These moun...
Page 19 - Operating the Monitor; Installing the Information Files
User’s Guide www.hp.com 4–1 4 Operating the Monitor Installing the Information Files The CD-ROM included with this monitor contains two information files to be installed onto your computer; an .INF file and an .ICM file. ■ The .INF file defines monitor resources and provides specifications used by m...
Page 20 - Front Panel Components
4–2 www.hp.com User’s Guide Operating the Monitor Front Panel Components No. Icon Control Function 1 PiP PiP button Activates Picture in Picture (PiP) window 2 input Signal Input button Signal input selection - scrolls through VGA, DVI-Analog, DVI-Digital, Super video, and composite video input 3 au...
Page 22 - Adjusting Monitor Settings
4–4 www.hp.com User’s Guide Operating the Monitor Adjusting Monitor Settings Press the Menu button on the front panel of the monitor to view the On Screen Display (OSD) Menu. The Main Menu window pops up and you can make adjustments to your monitor’s various features. Use the left, right, up, and do...
Page 26 - Identifying Special OSD Messages
4–8 www.hp.com User’s Guide Operating the Monitor Identifying Special OSD Messages Special OSD messages appear on the monitor screen when identifying the following monitor conditions: ■ Input Signal Out of Range, Change Setting to 1600 x 1200 - 60Hz—indicates the monitor is unable to access or fully...
Page 28 - Troubleshooting; Solving Common Problems
User’s Guide www.hp.com A–1 A Troubleshooting Solving Common Problems The following table lists possible problems, the possible cause of each problem, and the recommended solutions. Problem Possible Cause Solution Screen is blank. Power cord is disconnected. Connect the power cord. Power switch is t...
Page 29 - Using the Worldwide Web
A–2 www.hp.com User’s Guide Troubleshooting Using the Worldwide Web Before contacting customer services, refer to the support Web site at: http://www.hp.com/support Image appears blurred, indistinct, or too dark. Brightness and contrast are too low. Press the Menu button to open the OSD Menu, and ad...
Page 30 - Preparing to call Technical Support
Troubleshooting User’s Guide www.hp.com A–3 Preparing to call Technical Support If you cannot solve a problem using the troubleshooting tips in this section, you may need to call technical support. Have the following information available when you call: ■ The monitor ■ Monitor model number (on front...
Page 31 - Specifications
User’s Guide www.hp.com B–1 B Specifications Flat Panel Monitor L2035 DisplayType 20 inchesTFT LCD 51 cm Viewable Image Size 20-inch diagonal 51 cm TiltSwivel -5 to 25 o +35 to - 35 o Face Treatment Anti-glare polarizer with hard coating Maximum Weight(Unpacked) 21 lbs. 9.5 kg Dimensions (includes p...
Page 33 - Recognizing Preset Display Resolutions
Specifications User’s Guide www.hp.com B–3 Recognizing Preset Display Resolutions The display resolutions listed below are the most commonly used modes and are set as factory defaults. This monitor automatically recognizes these preset modes and they will appear properly sized and centered on the sc...
Page 34 - Entering User Modes; Using the Energy Saver Feature
B–4 www.hp.com User’s Guide Specifications Entering User Modes The video controller signal may occasionally call for a mode that is not preset if: ■ You are not using a Hewlett Packard standard graphics adapter. ■ You are not using a preset mode. If this occurs, you may need to readjust the paramete...
Page 36 - Agency Regulatory Notices
User’s Guide www.hp.com C–1 C Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against h...
Page 37 - Modifications
C–2 www.hp.com User’s Guide Agency Regulatory Notices Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett Packard may void the user's authority to operate the equipment. Cables Connections to this dev...
Page 38 - Canadian Notice
Agency Regulatory Notices User’s Guide www.hp.com C–3 To identify this product, refer to the Part, Series, or Model number found on the product. Canadian Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Avis Canadien Cet apparei...
Page 39 - Japanese Notice
C–4 www.hp.com User’s Guide Agency Regulatory Notices Japanese Notice Korean Notice EPA Energy Star Compliance Monitors that are marked with the Energy Star Logo meet the requirements of the EPA Energy Star program. As an Energy Star Partner, Hewlett Packard has determined that this product meets th...
Page 40 - Power Cord Set Requirements
Agency Regulatory Notices User’s Guide www.hp.com C–5 Power Cord Set Requirements The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate on input voltages between 100-120V or 200-240V. The power cord set (flexible cord or wall plug) recei...
Page 41 - HP Recycling Program
C–6 www.hp.com User’s Guide Agency Regulatory Notices HP Recycling Program HP offers product end-of-life return programs for HP and other manufacturers’ hardware in several geographic areas. The terms and availability of these programs vary by geography because of differences in regulatory requireme...
