Page 2 - Legal Notices
ii Legal Notices The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including,but not limited to, the implied warranties of merchantability and fitness for a particularpurpose. Hewlett-Packard sh...
Page 3 - Reader Comments; • Title of the manual you are referencing.
iii Reader Comments Reader Comments. We welcome your comments about our documentation. If you haveeditorial suggestions or recommend improvements for this document, please write to us.You can reach us through e-mail at: [email protected] or by sending your letterto: Documentation Manager, M/S ...
Page 4 - Preface; NOTE
iv Preface This Installation Guide contains technical information about HP 9000 Computers. The HP9000/Kxxo family of computers includes the following models: NOTE The Dual-Bus 4-Slot HP-HSC Expansion I/O Card may be installed ONLY onHP9000/K570 systems. HP9000/Kxx0 Servers HP9000 Workstations K100 H...
Page 5 - Installation Procedures; Electrostatic Discharge; bag until it is ready to be installed.; Anti-Static Wrist Strap
1 1 Installation Procedures HP9000/K570 systems, as with many other HP9000 systems, have a primary HP-HSCExpansion I/O slot for upgrades. This slot is immediately to the right of the Core I/O cardas viewed from the rear of the system (refer to Figure 1). HP9000/K570 systems can optionally use the sl...
Page 6 - Tools required
2 Anti-Static Mat The anti-static mat can be either the conductive bag, the ESD sheet, or the ESD foam pad.The anti-static mat does not have to be connected to the cabinet. It should be placed closeto the computer while performing the upgrade tasks. Tools required To accomplish the upgrade procedure...
Page 7 - Turn the computer key switch to the STANDBY position.
3 Installation Procedures Installation Procedures Installation Procedures NOTE A 2-slot or 4-slot HP-HSC Expansion I/O product must be present in theprimary HP-HSC Expansion I/O slot before adding the A3694A product to thesecondary HP-HSC Expansion I/O slot. 1. Log Off all users and stop all active ...
Page 8 - Figure 1; expansion connector on the system board.
4 Installation Procedures Installation Procedures Figure 1 HP9000/K570 Rear View 7. Remove the adjoining processor slot’s cover plate by loosening the two (one top and one bottom) captive mounting screws and pulling the cover plate away. (This is necessary togain access to the system board.) 8. Reac...
Page 9 - Figure 2; If this completes the upgrade, proceed to Upgrade Verification.; Upgrade Verification; Reconnect the power cord to the rear of the computer.
5 Installation Procedures Installation Procedures Figure 2 Screw Locations If this completes the upgrade, proceed to Upgrade Verification. Upgrade Verification Before performing the procedures in this section, make sure that all cover plates that wereremoved are reinstalled and secure. This is for p...
