HP 5500 C - Manuals - manualsarea.com

Page 2 - This module is organized into the following sections:

hp scanjet 4570c/5500c scanner Clean the underside of the scanner glass If cleaning the top surface of the scanner glass does not remove all dirt and smudges from the glass, you can also clean the underside of the glass. Cleaning the underside of the glass requires you to disassemble the scanner. Fo...

Page 3 - preparation; phillips screwdriver

preparation Tools needed: • phillips screwdriver Supplies needed: • Glass cleaner • lint-free cloths 1 Disconnect the USB cable between the scanner and computer. 2 Disconnect the power supply from the scanner. Wait at least 15 minutes (after disconnecting power) before dissembling the scanner and cl...

Page 4 - disassembly; emove the scanner lid; Open the lid and lift it straight up.; Scanner lid being removed; Clean top of the scanner

disassembly r emove the scanner lid After steps 1 and 2 have been completed and the scanner has cooled for 15 minutes, you can remove the lid as shown. 3 Open the lid and lift it straight up. Scanner lid being removed 4 Set the lid aside. Clean top of the scanner Clean the outside of the scanner pri...

Page 5 - un-fasten the top cover; Begin disassembly only after completing steps 1 through 6; location of the screws; Holding the top and bottom cover together,

un-fasten the top cover Begin disassembly only after completing steps 1 through 6 You are about to expose the interior of the scanner to the dust of the outside environment. the scanner is very sensitive to dust; any dust particles that get into the carriage head can cause streaks in the scanned ima...

Page 6 - After unscrewing the top cover, you are ready to remove it.; top cover being removed

remove the top cover After unscrewing the top cover, you are ready to remove it. top cover being removed 9 Carefully lift the top cover off the base. Lift the back of the top cover first then pull it out of the front bezel (bezel is referred to end containing the buttons and back is opposite of butt...

Page 7 - Cleaning; clean the glass; reassembly; into bezel first and then lower the back into place.; top cover being installed onto base

Cleaning clean the glass You are now ready to clean the underside of the glass. Use only glass cleaner. Avoid abrasives, acetone, benzene, and carbon tetrachloride, all of which can damage the scanner glass. Avoid isopropyl alcohol because it can leave streaks on the glass. Do not spray the glass cl...

Page 8 - insert the screws; Step #7 Insert the screws; location of screws; insert the scanner lid; scanner lid being re-inserted in scanner

12 Holding the top and bottom covers together, turn the scanner upside down on a clean surface. insert the screws 13 Re-insert and tighten the four screws with a Phillips screwdriver. Step #7 Insert the screws location of screws 14 Turn the unit over so that the glass side is facing up. insert the s...