Page 2 - PASLODE MODEL NUMBER DESIGNATION; STAPLER; NAILER; Tool application letter
PASLODE MODEL NUMBER DESIGNATION The model number of each Paslode tool contains information about the tool and the fastenersthat are used with it. The following example illustrates the information contained in this toolmodel number. STAPLER Tool application letter Maximum fastenerlength, in inches t...
Page 4 - WARNING; SAFETY INSTRUCTIONS
WARNING Failure to follow any of the above instructions could result in severe personalinjury to tool user and bystanders or cause damage to tool and property. Contact your local Paslode Representative for presentation of Paslode’s Safety Awareness Program SAFETY INSTRUCTIONS SAFETY FIRST These safe...
Page 5 - AIR SYSTEMS
5 AIR SYSTEMS For air-powered tools to work their best, the airsupply system must be properly installed andmaintained regularly. A drawing in this sectionshows a properly installed air supply system.Handy checklists for installing and maintaining air supply systems follow. Indoor Air System Installa...
Page 6 - AIR SYSTEMS; Calculating Compressor Size
AIR SYSTEMS - Continued Calculating Compressor Size Use the air consumption chart in the ToolSchematic for each tool when calculating theoperating requirements for the tools. Paslode tools are designed to operate efficientlybetween 80 and 120 psi and should never beoperated at pressure greater than ...
Page 8 - TOOL LOADING; Staplers
Precision Placement Driving ■ Grasp the tool handle firmly and hold the bottom of the work contacting element firmly against the workpiece until it is com-pletely depressed. ■ Squeeze the trigger to drive the fastener. ■ Lift the tool from the workpiece. ■ Repeat the procedure for the next fastener....
Page 9 - Coil Nailers
Coil Nailers Step No. 1 – Grasp the nailer handle firmly with onehand and with the other hand unlatch the magazinecover clip. Swing the magazine door open. Step No. 2 – Adjust the loading tray for nail length (ifrequired) by depressing the button on the post andraising or lowering the tray to the de...
Page 12 - MAINTENANCE; Cold Weather Care
MAINTENANCE Paslode ® tools are built for ease of maintenance. A few simple details will assure trouble-free operation and longtool life. Anyone who uses or maintains the tool must readthe safety and maintenance instructions. Study the sche-matic drawing before starting any repairs on the tool. Air-...
Page 13 - MAINTENANCE - Continued; MAINTENANCE TABLE
MAINTENANCE - Continued Drain air line filter(daily). Keep lubricator filled. Clean filter element-then blowair through filter in directionopposite to normal flow. Check that all screws on toolare tight. Keep work contacting elelmentworking properly. Keep magazine and feedermechanism clean. Lubricat...
Page 14 - OPERATOR TROUBLESHOOTING; PROBLEM
OPERATOR TROUBLESHOOTING PROBLEM CORRECTIVE ACTION Fasteners will not drive completely into wood. Fasteners penetrate properly during normaloperation, but won't drive fully at faster speeds. Fasteners drive too deeply into wood. Fastener jams in nose of tool. Tools skips during operation - no fasten...
Page 15 - TOOL WARRANTY; TOOL WARRANTY AND LIMITATIONS
TOOL WARRANTY TOOL WARRANTY AND LIMITATIONS An Illinois Tool Works Company888 Forest Edge DriveVernon Hills, Illinois 60061 P 15
