Page 2 - C US
௹ ௺ ௺ 1 This Product is Certified Ce produit est homologué Producto homologado por Este produto está registrado C US Printed: 12.11.2014 | Doc-Nr: PUB / 5206158 / 000 / 00
Page 5 - ORIGINAL OPERATING INSTRUCTIONS; driver; Contents
en 1 ORIGINAL OPERATING INSTRUCTIONS SID 2-A cordless impact screw- driver It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are ...
Page 6 - General information; serious personal injury or fatality.
en 2 1 General information 1.1 Safety notices and their meaning DANGER Draws attention to imminent danger that will lead to serious bodily injury or fatality. WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. CAUTION Draws attention ...
Page 7 - tightening and releasing nuts and bolts.
en 3 Symbols Return materials for recycling Direct current Rated speed under no load Forward rotation Reverse rotation Location of identification data on the power tool The type designation can be found on the type identification plate and the serial number on the side of the motor housing. Make a n...
Page 14 - Before use
en 10 d) Avoid ingress of moisture. Moisture in the interior of the tool may cause a short circuit and chemical reactions resulting in burns to the skin or fire. e) Observe the special guidelines applicable to the transport, storage and use of Li-ion batteries. f) Observe national and international ...
Page 15 - Operation
en 11 2. CAUTION A falling battery may present a risk of injury to yourself and others. Check that the battery is seated securely. 5.3 Removing the battery 3 1. Press the release button. 2. Pull the battery out of the cordless impact screwdriver towards the front. 5.4 Belt hook (accessory) 4 CAUTION...
Page 16 - Care and maintenance
en 12 6.3 Changing bits CAUTION Wear protective gloves when changing insert tools as the insert tools get hot during use.NOTE The power tool is equipped with a ¹/₄" hex. socket with locking sleeve that accepts various accessories such as drill bits, screwdriving bits and bit holders.Check that t...
Page 18 - Disposal
en 14 Fault Possible cause Remedy The power tool or the battery gets very hot. Electrical fault. Switch the tool off im- mediately, remove the battery and contact Hilti Service. The power tool has been overloaded (application limits exceeded). Use the right power tool for the job (don’t use a low-po...
Page 19 - 0 Manufacturer’s warranty - tools; the warranty conditions.
en 15 10 Manufacturer’s warranty - tools Please contact your local Hilti representative if you have questions about the warranty conditions. Printed: 12.11.2014 | Doc-Nr: PUB / 5206158 / 000 / 00
Page 20 - Hilti Corporation
*2081237* 2081237 Hilti Corporation LI-9494 Schaan Tel.: +423 / 234 21 11 Fax: +423 / 234 29 65 www.hilti.com Hilti = registered trademark of Hilti Corp., Schaan Pos. 3 | 20141007 Printed: 12.11.2014 | Doc-Nr: PUB / 5206158 / 000 / 00