Hilti 3497779 - Manuals

English 7 Electrical safety ▶ Before beginning work, check the working area for concealed electric cables or gas and water pipes. External metal parts of the power tool may give you an electric shock if you damage an electric cable accidentally. Power tool use and care ▶ Immediately switch off the p...

10 English 3 Description 3.1 Overview of the product Printed: 05.06.2019 | Doc-Nr: PUB / 5293030 / 000 / 04

12 English Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds after releasing the control switch. If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section. 4 Technical data 4.1 Cordless metal screwdriver...

14 English 5.3 Removing the battery ▶ Remove the battery. 5.4 Fitting / removing the depth gauge (optional) When driving screws with a sealing washer, use a depth gauge suitable for the diameter of the sealing washer (accessory). When the depth gauge is correctly adjusted the screw seal will be corr...

English 15 ▶ Use the protective cap. 5.6 Setting forward or reverse rotation An interlock prevents switching while the motor is running. The control switch is locked when the forward/reverse switch is in the middle position (safety lock). ▶ Set the forward/reverse switch to the desired direction of ...

16 English 5.7 Setting the torque ▶ Set the desired torque. 5.8 Safe operation WARNING Electric shock A fastener coming into contact with a concealed electric cable may result in electric shock. ▶ Never use the depth gauge or chuck as a gripping area. Always hold the tool by the grip and/or with the...

English 17 ▶ Switch the tool on. 5.10 Switching on in sustained operating mode The lockbutton can be pressed in while the control switch is pressed. The metal construction screwdriver then runs in sustained operating mode. The lockbutton makes the tool less tiring to use as the control switch does n...

18 English 5.12 Removing screws Remove the depth gauge or screw guide, if fitted. Set the forward / reverse switch to the “Reverse” position. ▶ Remove the screws. 6 Care and maintenance WARNING Risk of injury with battery inserted ! ▶ Always remove the battery before carrying out care and maintenanc...

English 19 ▶ Check the tool and batteries for damage before use after long periods of transport. Storage CAUTION Accidental damage caused by defective or leaking batteries ! ▶ Always store your products with the batteries removed! ▶ Store the tool and batteries in a place that is as cool and dry as ...

20 English Trouble or fault Possible cause Action to be taken LED 1 blinks. The battery is discharged. ▶ Charge the battery. The battery is too hot. ▶ Bring the battery to the recommended op- erating temperature. The battery is too cold. ▶ Bring the battery to the recommended op- erating temperature...

English 21 ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information. Battery disposal Improper disposal of batteries can result in health hazards from leaking gases or fluids. ▶ DO NOT send batteries through the mail! ▶ Cover the terminals ...