Zanussi ZDT41- Manual

Programme Degree of soil Type of load Programme description Any Partial load (to be completed later in the day) 1 cold rinse (to avoid food scraps from stick- ing). This programme does not require the use of detergent). 1) This is the perfect daily programme to clean a not fully load. Ideal for a fa...

Water hardness Water hardness setting °dH °TH mmol/l Clarke manually electronically 51 - 70 91 - 125 9,1 - 12,5 64 - 88 2 10 43 - 50 76 - 90 7,6 - 9,0 53 - 63 2 9 37 - 42 65 - 75 6,5 - 7,5 46 - 52 2 8 29 - 36 51 - 64 5,1 - 6,4 36 - 45 2 7 23 - 28 40 - 50 4,0 - 5,0 28 - 35 2 6 19 - 22 33 - 39 3,3 - 3...

1 2 3 Fill the salt container with 1 litre of water (only the first operation). 4 5 6 It is normal that water overflows from the salt con- tainer when you fill it with salt.Make sure that there is no grain of salt outer of the salt compartment. Salt which stays on the tank for a while drills the tan...

M A X 1 2 3 4 + 3 4 M A X 1 2 3 4 + 5 Fill when the rinse aid in- dicator ( B ) becomes clear. Caution! Do not fill the rinse aid dispenser with other products (e.g. dishwasher cleaning agent, liquid detergent). This can cause damage to the appli- ance. Adjusting the dosage of rinse aid M A X 1 2 3 ...

1 2 Use the cutlery grid. If the dimensions of the cutlery prevent use of the cutlery grid, remove it. 1 Arrange the items to let water touch all surfaces. 2 For longer items fold the cup racks up. Prevent to put plates in the first three sections in the front part of the upper basket. Make sure the...

3 Fill the detergent dispens- er (A) with detergent. 4 If you use a washing pro- gramme with prewash phase, put more detergent in the prewash detergent compartment (B). 5 6 Use of detergent tablets Put the detergent tablet in the detergent dispenser (A). Detergent tablets contain:• detergent• rinse ...

2. Release the programme selection/cancel button to cancel the washing programme. At this time you can do these steps:1. Switch off the appliance.2. Set a new washing programme. Fill the detergent dispenser with detergent before you set a new washing programme. Interrupting a washing programme Open ...

Important! Do not remove the spray arms.If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail stick. External cleaning Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive produ...

The cleaning results are not satisfactory The dishes are not clean • The selected washing programme is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces.• Spray arms do not turn freely because of incorrect arrangement of the lo...

Warning! To discard the appliance, follow the procedure: • Pull the mains plug out of the socket.• Cut off the mains cable and mains plug and discard them. • Discard the door catch. This prevents the children to close themselves inside the appliance and endanger their lives. Installation Warning! Ma...

3 4 The internal diameter must not be smaller than the diam- eter of the hose. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a block- age in the drain hose spigot. Caution! Make sure t...