Zanussi ZDI6142X - User Manual

Water outlet hose connection The end of the drain hose can be connected in the followingways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. 2. Hooked over the edge of the sink using the special cu...

Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with dishwasher ...

Rinse aid Rinse aid is automatically added during the last rinse, ensuringthorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about110 ml of rinse aid, which is sufficient for 16 - 40 dishwashingprogrammes, depending upon the dosage setting. F...

● Check if it’s necessary to refill with dishwasher salt or rinse aid ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. Loading cutlery and dishes Sponges, household cloths and ...

Use of detergent Only use detergents specifically designed for use indishwashers. Using no more then the correct amount of detergentcontributes to reducing pollution. Please observe the manufacturer’s dosing and storagerecommendations as stated on the detergent packaging. Fill with detergent 1. If t...

(1) This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of w...

1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Turn on the water tap 3. Close the dishwasher door 4. Setting and starting a programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with th...

Clean the external surfaces of the machine and control panelwith a damp soft cloth. If necessary use only neutraldetergents. Never use abrasive products, scouring pads orsolvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinseaid dispensers are cle...

If after all these checks, the problem persists, contact yourlocal Service Force Centre, quoting the model (Mod.), productnumber (PNC) and serial number (S.N.). This information can be found on the rating plate located onthe side of the dishwasher door (see picture). So that you always have these nu...