SIIG L704 - Manual
SIIG L704 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Caution; INSTALLATION AND OPERATING INSTRUCTIONS; Hardware Kit
- Page 3 – a) Wood Stud Installation; You should mark two positions total.; Step 1: Wall Plate Installation; Phillips head screw driver
- Page 4 – NOTE: The concrete anchors must be used for concrete installation.; Do not tighten until all bolts are in place.
- Page 5 – Step 2: Display Bracket Installation
- Page 6 – Check the mounting screws every two months for tightness.; Pull TV forward from the bottom and connect all TV cables & wires.; Maintenance
- Page 7 – Technical Support and Warranty
- Page 8 – PRODUCT NAME
04-0541B
TV Size: 32" - 55”
Max load capacity: 121lbs/55kg
Wall distance: 0.43/11mm
Bubble level included
Ultra-Thin LED/LCD TV Mount - 32" to 55"
IMPORTANT: If you don't understand the installation instructions, please consult an
installation specialist
Ultra-Thin LED/LCD TV Wall Mount
Material: 2.0mm Cold Rolled Steel Plate
Installation Instructions
Universal Mounting Pattern
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Caution A G B H-1 C H-2 D I E J F K L (×4) M8×16 screw (×4) M6×16 screw (×1) Bubble level (×4) M5×35 screw (×4) M8×80 bolt (×4) M8×35 screw (×4) M8 spacer (×4) M6×35 screw (×4) Concrete anchor It is recommended that two people perform the installation. Injury and/or damage can result from dropping o...
1 2 3 4 5 3 4 5 7 8 a) Wood Stud Installation You should mark two positions total. Stud finder for drywall installation NOTE: When mounting to wood studs, the two wood studs must be a minimum of 16" apart. Use a high-quality electronic stud finder (commercially available) to locate dead center o...
2 3 4 5 6 7 8 9 NOTE: The concrete anchors must be used for concrete installation. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Tighten the bolt with the 1/2" socket or 1/2" open-end wrench by turning clockwise until tight. CA...
