SIIG II-150 - Manual
SIIG II-150 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Hardware Installation; Note
- Page 4 – Driver Installation
- Page 6 – Next; Windows Vista; Load Driver
- Page 8 – To Verify Windows Vista Installation
- Page 10 – Close; To Verify Windows Server 2008 Installation; Diagnostics; BIOS Configuration
- Page 11 – Technical Support and Warranty; s Online Support has answers! Simply visit our
1
SATA II-150 PCI
Quick Installation Guide
Introducing the SATA II-150 PCI
The SATA II-150 PCI is an ultra high-speed dual channel
Serial ATA Generation 2 controller for use in PCI enabled
systems.
Features and Benefits
•
Add up to two high-speed SATA hard drives
•
New Serial ATA cable
–
easier to install & provides
better air circulation
•
Supports two SATA channels and data transfer rate
up to 1.5Gb/s (150MB/s)
•
Supports Native Command Queuing (NCQ) and
SATA TCQ commands
•
Onboard bus master engine relieves the system
processor from book keeping and enhances
performance
•
Features independent 256-byte FIFOs per channel
for host reads and writes
•
Breaks the 137GB barrier! Works with various
brands of large capacity Serial ATA hard disks
•
Supports SATA hard disk hot-plugging
•
Compliant with PCI 2.3
•
Compliant with Serial ATA 1.0 specifications and
complement of SATA II optional features
04-0409D
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 Hardware Installation Note : For low profile systems, replace the currently mounted bracket with the included low profile bracket.General instructions for installing the card are providedbelow. Since the design of computer cases andmotherboards vary, refer to your computer ’ s reference manual for...
4 Driver Installation This section provides information on how to install theSATA II-150 PCI drivers for the following operatingsystems. Windows 2000 New Windows 2000 InstallationA new installation of Windows 2000 requires a floppydisk for the driver installation. To make this floppy disk,copy the c...
6 3. Insert the driver CD, select Install the software automatically (Recommended) , then click Next, Next . 4. Click Continue Anyway, then click Finish. 5. Restart Windows to complete the driver installation. To Verify Windows 2000/XP/2003 Installation 1. Right click My Computer and click Manage. 2...
