SIIG 3.1 - Manual

SIIG 3.1

SIIG 3.1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 3 – System Requirements; • PC or Mac; Package Contents; USB 3.1 to SATA 2.5 External Hard Drive Enclosure; Layout
  • Page 4 – Hardware Installaion; enclosure, and please handle storage device with; Remove the 2 screws on both sides, see; Figure 3
  • Page 5 – Take off the PCB and connect it to the hard disk drive,; Figure 5; and; Figure 6
  • Page 6 – Put the installed PCB with hard disk drive into the hard; Figure 7
  • Page 7 – Hold onto the hard disk drive and turn the hard disk; Figure 8
  • Page 9 – Blank Page
  • Page 11 – Technical Support and Warranty
Loading the manual

1

USB 3.1 to SATA 2.5 External

Hard Drive Enclosure

Installation Guide

Introduction

The

USB 3.1 to SATA 2.5 External Hard Drive Enclosure

easily adds additional external storage ( 2.5" HDD /

SSD) up to 8TB via the latest generation USB 3.1

technology with data transfer rates up to 10Gb/s (2x

faster than USB 3.0).

04-0989A

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - System Requirements; • PC or Mac; Package Contents; USB 3.1 to SATA 2.5 External Hard Drive Enclosure; Layout

3 System Requirements • PC or Mac ® with an available USB port (USB 3.1 recommended) • Windows ® XP or later • Mac OS ® X v10.8.x or later Package Contents • USB 3.1 to SATA 2.5 External Hard Drive Enclosure • USB 3.1 Y-split (data and power) cable• Installation kit• Installation guide Layout Power ...

Page 4 - Hardware Installaion; enclosure, and please handle storage device with; Remove the 2 screws on both sides, see; Figure 3

4 USB Data Connector (to computer) USB Power Connector (to computer / optional) USB Data Connector (to enclosure) USB 3.1 Y-split (data and power) cable Figure 2: USB 3.1 Y-split (data and power) cable Hardware Installaion Below shows how to install 2.5" HDD / SSD into the enclosure, and please ...

Page 5 - Take off the PCB and connect it to the hard disk drive,; Figure 5; and; Figure 6

5 screws (x2) Figure 3 screws (x2) Figure 4 2. Take off the PCB and connect it to the hard disk drive, see Figure 5 and Figure 6 .

Other SIIG Models

All SIIG Other