SIIG 16550 - Manual
SIIG 16550 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Package Contents; ports; Layout; Note; : Make sure the stripe on the ribbon cable is
- Page 3 – Hardware Installation; cable
- Page 4 – Driver Installation; UART
- Page 9 – To Verify Windows Installation; For Windows Vista
- Page 12 – DOS
- Page 13 – Blank Page
- Page 15 – Technical Support and Warranty
1
04-0722B
4-Port RS232 Serial PCI
with 16550 UART
Quick Installation Guide
I
ntroduction
The
4-Port RS232 Serial PCI with 16550 UART
is
a high-speed serial card that provides four
additional serial ports to your system.
Key Features and Benefits
•
Compliant with PCI Local Bus Specification,
Revision 2.3
•
Supports data transfer rate up to 230Kb/s
•
Supports up to 256-byte FIFO buffer
System Requirements
•
Pentium
®
or equivalent computer with an
available 32-/64-bit PCI or PCI-X slot
•
Windows
®
8 (32-/64-bit) / 7 (32-/64-bit) /
Vista (32-/64-bit) / XP (32-/64-bit) / Server
2003 & 2008 (32-/64-bit) / Server 2008 R2
/ 2000 / ME / 98SE / 98 / DOS
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Package Contents • 4-Port RS232 Serial PCI with 16550 UART • Slot bracket with 2 DB9 (9-pin) serial ports • Driver CD • Quick installation guide Layout Figure 1: Layout Note : Make sure the stripe on the ribbon cable is align to the pin 1 of the serial header when connected for proper connection. ...
3 Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your c o m p u t e r ’ s r e f e r e n c e m a n u a l f o r f u r t h e r information, if needed.Static Electricity Discharge may permanently d...
4 5. To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated. 6. Replace the slot bracket's holding screw to secure the card. 7. Mount the second serial port and secure it with the sl...
