SIIG 04-0621B - Manual
SIIG 04-0621B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Caution; INSTALLATION AND OPERATING INSTRUCTIONS
- Page 3 – a) Wood Stud Installation; Figure 1; You should mark four positions total. Take down the wall plate.; CAUTION; Step1: Wall Plate Installation; Stud finder for drywall installation
- Page 4 – Figure 4; Step 2 Display Plate Installation
- Page 5 – Swivel Adjustment; Tighten the middle screw to secure the tilt angle (Figure 10).; Check the mounting screws every two months for tightness.; Maintenance
- Page 6 – Blank Page
- Page 7 – Technical Support and Warranty
- Page 8 – PRODUCT NAME
04-0621B
TV size: 23" - 42"
Installation and Operating Instructions
Wall distance: 3.75" / 95mm
Bubble level included
Universal Mounting Pattern
IMPORTANT
: If you have difficulty following or understanding these installation instructions,
please consult a qualified installation specialist.
Max load capacity:100 lbs
Tilt angle: 0-12 degrees
Full Motion TV Mount - 23" to 42"
Full-motion/articulating universal LCD/Plasma TV wall-mount
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
A H (×6) bolt B I (×4) M8/M6/M5 rectangular washer C J-1 (×6) M8 washer D J-2 E K (×4) spacer F L (x1) wrench G M (×4) M5×35 screw (×6) M8 concrete anchor (×4) M8×35 screw (×4) M6×35 screw The wall structure must be capable of supporting at least the maximum load capacity as indicated. If not, the w...
1 2 3 4 a) Wood Stud Installation Figure 1 3 4 Figure 2 5 6 7 8 Figure 3 For each location, insert a bolt (H) and washer (J) into the wall. Attach the bubble level (J-2) to the wall plate and with the help of anassistant ensure the wall plate is level, position the wall plate againstthe wall in the ...
1 2 3 4 5 6 7 Figure 4 1 2 3 4 Figure 5 Figure 6 Figure 6-1 If your display has a curved back or a recessed thread mounting point, a spacer (K) must be used. Then choose screw (D/E/F) to match. Place the spacer (M) between the mounting bracket and display (Figure 6-1). Insert a concrete anchor (G) i...
