SIIG 04-0529D - Manual
SIIG 04-0529D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Caution; INSTALLATION AND OPERATING INSTRUCTIONS
- Page 3 – Step 1: Wall plate installation; A) Wood Stud Installation
- Page 4 – Check the mounting screws every two months for tightness.; Maintenance; NOTE: The concrete anchors must be used for concrete installation.; Step 3 Final Installation & Adjustment
- Page 5 – Blank Page
- Page 7 – Technical Support and Warranty
- Page 8 – PRODUCT NAME
04-0529D
Wall distance: 3.3" / 84mm
Universal Mounting Pattern
IMPORTANT: If you don't understand the installation instructions, please
consult an installation specialist
Bubble level included
Material: 2.0mm Cold Rolled Steel Plate
TV Size: 32" - 60"
Tilt: 0 / +15 degrees
Maximum load capacity: 165 lbs / 75 kgs
Installation Instructions
Tiltable LCD / TFT TV Wall Mount
Universal Tilting TV Mount - 32" to 60"
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
A-1 G A-2 (x1) Key H B I C J D K E L-1 F L-2 (x1) Bubble Level M (×4) M8 Spacer 1 Phillips head screw driver 2 Stud finder for drywall installation 3 5/16" Socket and Wrench 4 (×4) M4×12 screw Caution CAUTION: The maximum load capacity is 165 lbs. Use with products heavier than the maximum load ...
Note: Step 1: Wall plate installation 1 3 4 You should mark four positions total. 5 6 7 8 CAUTION: CAUTION: Mark the right (upper and lower) and the left (upper and lower)positions of the small horizontal slots that are in alignment withthe studs. Position the wall plate against the wall and line up...
1 2 3 4 Insert a concrete anchor (K) into to each hole. 5 6 7 4 5 1 2 3 4 Check the mounting screws every two months for tightness. Hook the TV rails over the top of wall plate (3-a). If your display has a curved back or a recessed thread mountingpoint, place the spacer (M) between the mounting brac...
