SIIG 04-0205F - Manual
SIIG 04-0205F – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Hardware Installation
- Page 3 – Driver Installation; Windows Driver Installation; Computer; For Windows Vista
- Page 4 – For Windows 7 / Vista
- Page 5 – Blank Page
- Page 7 – Technical Support and Warranty; Online Support
- Page 8 – features, and are backed by an extensive manufacturer warranty.; FCC COMPLIANCE STATEMENT:
1
Low Profile USB 2.0
Quick Installation Guide
0 4 - 0 2 0 5 F
Features and Benefits
•
Compliant with USB specifications revision 2.0
•
Conforms to PCI specifications revision 2.2
•
Supports simultaneous operation of multiple
high-speed USB 2.0 and USB 1.1 devices
•
Supports high-speed (480 Mbps), full-speed (12
Mbps), and low-speed (1.5 Mbps) data transfer
modes
•
User friendly hot-swapping feature allows you to
attach/remove USB devices without turning off
your system
Note:
USB 1.1 devices are limited to USB 1.1 speeds
even when they are connected to USB 2.0 host adapter
or USB 2.0 hubs.
System Requirements
•
Pentium
®
class computer with an available PCI slot
•
Windows
®
7 (32-/64-bit) / Vista (32-/64-bit) / XP
(32-/ 64-bit) / Server 2003 & 2008 (32-/64-bit) / 2000
SP4
Dimensions
•
PCB: 119.91 mm (L) x 64.41 mm (H)
•
Bracket: 18.42 mm (W) x 79.20 MM (H)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Package Contents • Low Profile USB 2.0 • Quick Installation Guide Layout Figure 1: Layout Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further informati...
3 3. Remove the slot bracket from an available PCI slot. 4. Carefully align the card to the selected PCI slot, push the board down firmly, but gently, until it is well seated. 5. Replace the slot bracket holding screw to secure the card. 6. Replace the computer cover and reconnect the power cord. Dr...
4 2. The drivers show up differently under different versions of Windows. Please refer to the correct Windows version to verify. For Windows 7 / Vista : Under Universal Serial Bus controllers, NEC to PCI Universal Host Controller will be displayed two times and Standard Enhanced PCI to USB Host Cont...
