Page 2 - CONTENTS
Page(s) Safety Instructions and Electrical Safety 3 - 5 Electrical Safety 6 Feature Diagram 7 Control Panel Diagram 8 Installing your Air Conditioner 9 - 11 Using your Air Conditioner 12 - 21 Draining your Air Conditioner 22 – 24 Cleaning your Air Conditioner 25 Start/End of Season Operations 26 Tro...
Page 3 - Safety Instructions
Safety Instructions Important note: Please read this booklet before installing and switching on this appliance. The manufacturer assumes no responsibility for incorrect installation and usage as described in this booklet. • This model uses natural refrigerant gas as part of its coolingsystem. This g...
Page 6 - Electrical Safety; THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET
Electrical Safety THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET • Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz. Connection to any other power source may...
Page 7 - FEATURE DIAGRAM; Front; Condensation drain
FEATURE DIAGRAM For Customer Services & Spare Parts please call 0345 209 7461 Or visit us at mda.russellhobbs.com Front 1. Control panel2. Handle (both sides)3. Castors4. Deflector 13. Remote control slot Rear 5. Intake grill6. Air outlet grill7. Intake grill8. Power cable9. Plug fixer10. Conden...
Page 8 - CONTROL PANEL DIAGRAM
CONTROL PANEL DIAGRAM Front 1. Timer button2. Fan button3. Increase button4. Display screen5. Decrease button6. Mode button7. ON/OFF button Rear A. Cool modeB. Dehumidify modeC. Fan modeD. High fan speedE. Low fan speedF. Timer mode RHPAC3001 r4.1 8
Page 9 - Exhausting Hot Air; INSTALLING YOUR AIR
Exhausting Hot Air In the COOL mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position the unit on a flat floor and make sure there is a minimum of a 45cm (18inch) clearance around the unit and ensure this is within the vicini...
Page 10 - Location
Location • The unit should be placed on firm ground to help minimise noise and vibration. For safe and secure positioning, place the unit on a smooth, level floor which is strong enough to support the unit. • This unit has castors to aid placement but it should only be rolled on smooth, flat surface...
Page 11 - INSTALLING YOUR WINDOW KIT
Your Russell Hobbs Air Conditioner has been supplied with a Window Sealing Kit. The kit is suitable for use on UPVC windows that open internally or externally either 3 sides, or 4 sides. It is not suitable for middle opening windows such as skylights, or wooden frames. The maximum aperture dimension...
Page 12 - USING YOUR AIR CONDITIONER; Operating from the control panel
USING YOUR AIR CONDITIONER Operating from the control panel The control panel is on top of the appliance and it enables you to manage functions without using the remote control. However, to use the appliance to its full potential you are advised to use the remote control. To turn the appliance on pl...
Page 14 - Switching the unit of temperature
USING YOUR AIR CONDITIONER Switching the unit of temperature Hold both the INCREASE and DECREASE buttons at the same time until the appliance beeps (approx. 5 seconds). Once the appliance has beeped you will be able to change the unit of temperature. For example: Before change and when in cool mode ...
Page 16 - Operating from the remote control
Operating from the remote control USING YOUR AIR CONDITIONER On/Off button Mode button Night Mode button Increase button Decrease button Function not present on this appliance Fan button Timer button Unit Switch button • Point the remote control at the receiver on the appliance. • The remote control...
Page 22 - DRAINING YOUR AIR CONDITIONER; Water drainage method
DRAINING YOUR AIR CONDITIONER Water drainage method When there is excess water condensation inside the unit, the appliance will stop running and ‘Ft’ will display (FULL TANK as mentioned in the self diagnosis). This indicates that water needs to be drained out using one of the following procedures. ...
Page 24 - Middle drainage
DRAINING YOUR AIR CONDITIONER Middle drainage When the unit is running in DEHUMIDIFY mode, you can chose to drain the appliance through the middle drainage hole. This is done as follows: 1. Unplug the unit from the power source 2. Remove the drain plug (Fig A). While doing this some residual water m...
Page 25 - CLEANING YOUR AIR CONDITIONER
CLEANING YOUR AIR CONDITIONER Before any cleaning or maintenance, turn the appliance off by pressing the ON/OFF button on either the control panel or remote control, wait for a few minutes and then unplug the appliance from the mains socket. Cleaning the cabinet You should clean the appliance with a...
Page 26 - START/END OF SEASON OPERATIONS
START/END OF SEASON OPERATIONS Start of season checks Make sure the power cable and plug are undamaged and the earth system is efficient. Follow the installation instructions within this manual precisely. End of season operations To empty the internal circuit completely of water, remove the cap and ...
Page 27 - TROUBLESHOOTING
TROUBLESHOOTING PROBLEM CAUSE SOLUTION The appliance does not come on -There is no current-It is not plugged into the mains -The internal safety device has tripped -Wait-Plug it into the mains -Wait 30 minutes and if the problem persists please contact our Customer Service team on 0345 209 7461. The...
Page 28 - GUARANTEE AND CUSTOMER SERVICES
GUARANTEE AND CUSTOMER SERVICES At Russell Hobbs, we take all our customer feedback seriously. Feel free to contact our Customer Service Team, on 0345 209 7461 who will be more than happy to assist you. This product is guaranteed for 12 months from the date of the original purchase. If any defect ar...
Page 29 - SPARE PARTS; Remote Control
SPARE PARTS For Customer Services & Spare Parts please call 0345 209 7461 Or visit us at mda.russellhobbs.com To check the availability of the following spare parts, simply contact our friendly Customer Services team using the details provided at the bottom of this page. Remote Control Exhaust H...
Page 30 - SPECIFICATION
SPECIFICATION Model RHPAC3001 / RHPAC3001B Voltage 220 – 240V 50Hz Power Input 780W Maximum Cooling Capacity 7000 BTU Suitable Room Size 8-14 (m2) Refrigerant R290/0.17kg Overall Size (W x H x D) 32 x 67 x 32 (cm) Weight 24.5 KG Moisture Removal 0.6 L/hr Operating Temperature 18°C - 35°C Operating H...
Page 31 - NOTES