Quadra-Fire SANTAFEI-CE-MBK - Manual

Table of Contents:

• Page 2 – Page 2; Castile & Santa Fe CE Insert; and Welcome to the Quadra-Fire Family; NOTE: Consult insurance carrier, local building inspector, fire; SANTA FE CE PELLET INSERT
• Page 3 – Page 3; TABLE OF CONTENTS; Safety Alert Key:; Specifications; User’s Guide; C. Minimum Opening for Masonry and
• Page 4 – Page 4
• Page 5 – Page 5
• Page 6 – Listing and Code Approvals; Hearth & Home Technologies
• Page 7 – Glass and other surfaces are hot during operation AND cool down.; Hot glass will cause burns.; WARNING; WARNING! Do not operate appliance before reading and
• Page 8 – Combustible Material; C. Fuel Material and Fuel Storage; CAUTION; urn fuel that contains an additive; Tested and approved for wood pellets. Burning
• Page 9 – Thermostat Calls For Heat; High; Reset; E. Before Your First Fire; F. Filling the Hopper with Fuel
• Page 10 – Figure; Odors and vapors released during initial operation.; Feed Adjustment Control Rod
• Page 11 – DO NOT LEAVE FIREPOT FLOOR OPEN; NOT
• Page 12 – Maintaining & Servicing Your Appliance; C. General Maintenance; Depending on the type of fuel you are burning will dictate how; Shock and Smoke Hazard; A. Proper Shutdown Procedure; B. Quick Reference Maintenance Chart; Cleaning or Inspection; Frequency; the recommended interval or you see soot coming from the vent.
• Page 13 – Disposal of Ashes; Cleaning Firepot with Cleaning Rod & Firepot
• Page 14 – Cleaning; use a heavy duty vacuum cleaner specifically
• Page 16 – Incorrect; IMMEDIATE ATTENTION AND CLEANING IS REQUIRED.
• Page 17 – Troubleshooting for Homeowner; A. Frequently Asked Questions
• Page 18 – Getting Started; Installer’s Guide; WARNING! Risk of Fire; Appliance Location; Check building codes prior to installation.
• Page 19 – Tools and building supplies normally required for instal-; C. Tools And Supplies Needed; Damaged parts could impair safe; • Read all the instructions before starting the installation.
• Page 20 – Dimensions and Clearances; A. Appliance Dimensions; Overall Size; Panel; Standard; CASTILE ONLY
• Page 21 – Inches; E. Prefabricated Metal Chimney; * the Castile and Santa Fe inserts are only intended
• Page 22 – Do not terminate vent; in any enclosed or semi-enclosed; A. Venting Termination Requirements; Vent Information; B. Avoiding Smoke and Odors
• Page 23 – Vent Configurations
• Page 24 – Use 24 gauge single wall flue connector or; INSTALL VENT AT CLEARANCES SPECIFIED BY THE; Exhaust Venting; NOTE: All pipe must be welded seam pipe whenever pos-
• Page 25 – Substitute or damaged vent components may; 5° elbow is equivalent to 30.48cm of straight pipe; Miniumum Vertical Vent for Two Elbows; TWO 90o ELBOWS
• Page 26 – Venting Systems; A. Full Reline With Horizontal Outside Air
• Page 27 – Check clearances carefully for this type of
• Page 28 – Parts Included in Kit:; Never draw outside combustion air from:; Leveling Bolt on each Side
• Page 29 – Height Adjustment; top; Sheet metal trim edges will be sharp.
• Page 30 – Item; Panel Extension, 127mm; Install Sides; Turn right side up and attach top cast ring; . Lay hearth support’s front and sides face down. Bend the
• Page 31 – Parts Needed
• Page 32 – ncluded in Surround Kit:; Clearance Notch
• Page 33 – Attach panel; Back view of panel
• Page 34 – Two Piece Log Set Installation; J. Optional Log Set Placement Instructions; Logs are FRAGILE. Use extreme care when handling or
• Page 35 – • Do NOT remove grounding prong from plug.
• Page 36 – CONTACT INFORMATION; For the number of your nearest Quadra-Fire dealer; foreign patents pending.; NOTICE; DO NOT DISCARD THIS MANUAL; DO NOT