Patton 2888 - Manual
Patton 2888 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – OnSite 2888 Quick Start Guide; Powering up the OnSite; Connecting the power supply; Connect the AC power cord male plug to an AC power outlet (120–240 VAC).; DC Power
- Page 3 – Connecting DC Power to the 2888 DC Power Supply; WARNING
- Page 4 – Setting the IP address; Default IP configuration; The factory default IP settings are as follows:; Connecting to the PC and logging in via the Ethernet port; Connecting to the PC’s ENET port; Log into the unit using the following:; admin
- Page 5 – Connecting to the PC’s Console port; Changing the IP address; Saving the IP address
- Page 6 – The 2888 comes with either two or four T1/E1 ports.; Connecting the T1/E1 ports; To connect the twisted pair cable to the T1/E1 port:; Additional information; OnSite Model 2888 User Manual
- Page 7 – A.0 Compliance Information; A.2 CE Declaration of Conformity; The signed Declaration of Conformity can be downloaded from; A.3 Authorized European Representative
- Page 8 – Copyright statement; OnSite; Patton support headquarters in the USA; Note; Warranty, Compliance Information
OnSite 2888
T1/E1 Multi-Megabit Inverse Mux
Quick Start Guide
Important
—This is a Class A device and is intended for use in a light industrial environment. It is not
intended nor approved for use in an industrial or residential environment.
Part Number:
07M2888-QS, Rev. B
Revised:
February 23, 2012
Sales Office:
+1 (301) 975-1000
Technical Support:
+1 (301) 975-1007
E-mail:
WWW:
www.patton.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 OnSite 2888 Quick Start Guide 1.0 Powering up the OnSite 1.1 Connecting the power supply AC Power 1. Connect the AC power cord female plug directly to the OnSite AC connector. 2. Connect the AC power cord male plug to an AC power outlet (120–240 VAC). The Power LED blinks as the OnSite is powering...
IPLink 2884/2888 Quick Start Guide 3 Figure 1. Connecting DC Power to the 2888 DC Power Supply Figure 2. 2888 rear panel There are no user-serviceable parts in the power supply section of the Model 2888. Contact Patton Electronics Technical support at (301)975-1007, via our web site at http://www.pa...
4 OnSite 2888 Quick Start Guide 2.0 Setting the IP address 2.1 Default IP configuration The factory default IP settings are as follows: • LAN port (ETH 0): IP address: 192.168.200.10, Netmask: 255.255.255.0, DHCP client If this address conflicts or does not match with your network, it must be change...
