Heath Zenith SL-5318 - Manual

Heath Zenith SL-5318

Heath Zenith SL-5318 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – INSTALLATION; Wall Mount
  • Page 3 – TEST AND ADJUSTMENT; Bottom of Sensor; SPECIFICATIONS
  • Page 4 – See your Canadian Tire retailer for warranty information.; TROUBLESHOOTING GUIDE
  • Page 5 – Características; FUNCIONAMIENTO; Requisitos; PRUEBA; Luz De Adorno
  • Page 6 – INSTALACION; Montaje en pared
  • Page 7 – PRUEBA Y AJUSTE; Parte de abajo del detector; ESPECIFICACIONES
  • Page 8 – GUIA DE INVESTIGACION DE AVERIAS
  • Page 9 – Caractéristiques; à détecteur; Exigences; FONCTIONNEMENT; Résumé du mode de commutation; Minuterie Dual BriteTM
  • Page 10 – Montage mural
  • Page 11 – Bas du détecteur; ESSAIS ET RÉGLAGES; FICHE TECHNIQUE
  • Page 12 – GUIDE DE DÉPANNAGE
Loading the manual

Model SL-5318

Dual Brite

Motion

Sensor Light
Control for
Canadian Tire

© 2003 DESA Specialty Products™

598-1001-02

Light Control

Sensor

Cover

Plate

Lamp Holders

2 Wire Connectors

6 Screws

(3 sizes included)

Gasket

2 Shells

Features

• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Dual Brite™ Timer.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).

Requirements

• The Light Control requires 120-volts AC.
• If you want to use the Manual Mode, the control must

be wired through a switch.

Some codes require installation by a qualified

electrician.

• This product is intended for use with the enclosed

gasket and with a junction box marked for use in wet
locations.

Mounting Bolt

Mounting Strap

Rubber Plug

Plastic Hanger

This package includes:

TEST

TEST 1 5 20

ON-TIME

Off 3 6 Dusk to

Dawn

DUAL BRITE™

Put ON-TIME switch on
the sensor bottom to
TEST and the Dual
Brite™ switch OFF.

Dual Brite™ TIMER

Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). If motion is sensed, the light
turns on full bright for the ON-TIME (1,5, or 20 minutes)
then returns to dim mode.

Mode:

On-Time:

Works:

Day

Night

Test

5 Sec

x

x

Auto

1, 5, 20 min.

x

Manual

Until Dawn*

x

OPERATION

* resets to Auto Mode at dawn.

MANUAL MODE

ON-TIME

TEST 1 5 20

... back on.

AUTO

1 Second OFF

then...

Move ON-TIME Switch to

1, 5, or 20 minutes

Mode Switching Summary

Flip light switch off

for one second then

back on*

MANUAL MODE

AUTO

TEST

* If you get confused while switching modes, turn the

power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.

Note: When first turned on wait about 1

1

/

2

minutes for

the circuitry to calibrate.

Manual mode only works at night
because daylight returns the sensor
to AUTO.

Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.

Manual mode works only with the ON-
TIME switch in the 1, 5, or 10 position.

Put the ON-TIME switch in the 1, 5, or
20 minute position.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - INSTALLATION; Wall Mount

598-1001-01 2 1234567890123456789 1234567890123456789 1234567890123456789 INSTALLATION For easy installation, select an existing light with a wallswitch for replacement. For eave mount only: ❒ Swing the sensor head towards the clamp screwjoint. If the sensor pops out of the ball joint, loosen thecla...

Page 3 - TEST AND ADJUSTMENT; Bottom of Sensor; SPECIFICATIONS

598-1001-01 3 Motion Motion 8 ft. (2.4 m) 70 ft. 100 ft. (21 m) (30.5 m) Boosted Sensor 240 ° B O O S T MAX MIN R A N G E ON - TIME DUAL BRITE TEST 1 5 2 0 MINUTES OFF 3 6 DUSK TO HOUR DAWN TEST AND ADJUSTMENT ❒ Turn on the circuit breaker and light switch. NOTE: Sensor has a 1 1 / 2 minute warm up ...

Page 4 - See your Canadian Tire retailer for warranty information.; TROUBLESHOOTING GUIDE

598-1001-01 4 See your Canadian Tire retailer for warranty information. SYMPTOM Lights will not comeon. L i g h t s c o m e o nin daylight. Lights come on forno apparent rea-son. Lights turn off tool a t e i n D u s k - t o -Dawn setting POSSIBLE CAUSE 1. Light switch is turned off.2. F l o o d l i ...

Other Heath Zenith Models

All Heath Zenith Other