Heath Zenith SL-6107 - Manual

Heath Zenith SL-6107

Heath Zenith SL-6107 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
Page: / 30

Table of Contents:

  • Page 2 – INSTALLATION; For your safety, turn off power at the fuse or circuit breaker.
  • Page 4 – Remove remote switch from the junction box.; Connect Jumper at the Remote Switch
  • Page 6 – Test For Correct Common Wire Connection:
  • Page 7 – Troubleshooting Wiring Connections
  • Page 8 – SPECIAL INSTALLATIONS; SINGLE SWITCH INSTALLATION
  • Page 9 – ADJUSTMENT; Dark; PHOTO SENSITIVITY
  • Page 10 – Outlet Cover Plate; Seconds
  • Page 11 – USING THE LIGHT CONTROL; When you want the light off all the time.; The light will not be switched on by either switch.; Put the control; OPERATIONS
  • Page 12 – TROUBLESHOOTING
  • Page 13 – In the Auto mode, light does not stay on:; Turn the Time control; In the Auto mode, light turns on in daylight:; • Photo adjustment not set properly.; If the problem; No Service Parts Available for this Product
  • Page 14 – Rapid Start Ballast; Specification subject to change without notice.; Not designed for use with compact; Minimum of two tubes required.; Note: May not be used to operate; SPECIFICATIONS
  • Page 15 – FIVE YEAR LIMITED WARRANTY; Light bulbs are not covered.; To obtain a refund or a
  • Page 16 – controla automáticamente la ilumina-; • E n l a; m o d a l i d a d d e A U T O ,; e l c o n t r o l; Perfecto para cuartos o pasillos; © 2003 DESA Specialty ProductsTM
  • Page 17 – INSTALACION; Instalaciones Especiales,; Nota: Puede que no se use para; Nota: Al interruptor existente de 3 direcciones se le llamará
  • Page 19 – Una el cable de conexión al interruptor tridireccional; Quite el interruptor a control remoto de la caja de empalme.; Conecte el Cable Conector en el Interruptor a Control
  • Page 20 – Instale el Detector de Movimiento en el otro
  • Page 21 – Prueba para la conexión correcta de un cable común
  • Page 22 – Conexiones de cableado para análisis de averías
  • Page 23 – como se; INSTALACIONES ESPECIALES; Para; instalaciones; INSTALACIÓN DE UN SOLO INTERRUPTOR
  • Page 24 – Obscuro
  • Page 25 – Tapa de la salida; Segundos
  • Page 26 – Cuando quiere que la luz esté siempre apagada.; La luz no se prenderá con ninguno de los dos interruptores.; Coloque el control en esta posición cuando cambie bombillas.
  • Page 27 – INVESTIGACION DE AVERIAS
  • Page 28 – La luz no se prende cuando está en automático:; SERVICIO TÉCNICO
  • Page 29 – ESPECIFICACIONES
  • Page 30 – GARANTÍA LIMITADA A 5 AÑOS; Las bombillas no están; Para obtener el reembolso o reemplazo, devuelva el producto
Loading the manual

SL-6107

© 2003 DESA Specialty Products™

595-4514-13

The Heath

®

/Zenith Motion Sensing 3-Way Wall

Switch

automatically controls indoor lighting:

• In

AUTO mode,

the control automatically turns

the light on when you enter the room. The length
of time the light stays on is adjustable.

The Heath

®

/Zenith SL-6107 Motion Sensing 3-Way

Wall Switch replaces any “3-way” switch.

Perfect

for rooms or hallways where two wall switches
control a single light.

This package includes:
• light control
• wire connectors
• wire jumper

• decorative cover plate
• mounting hardware

MOTION SENSING

3-WAY WALL SWITCH

AUTO

OFF

ON

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - INSTALLATION; For your safety, turn off power at the fuse or circuit breaker.

595-4514-13 -2- Some local building codes may require installation by a quali-fied electrician. INSTALLATION ❐ For your safety, turn off power at the fuse or circuit breaker. Note: A “3-way” circuit controls lights from two separate switches.If you want to use this product in a single switch circuit...

Page 4 - Remove remote switch from the junction box.; Connect Jumper at the Remote Switch

595-4514-13 -4- The switch may indicate the common OR Color of screw may be different for the common INSTALLATION 1. Add Jumper At Remote 3-Way Switch. A jumper wire between the common wire and one of the switchedwires is used to supply power to the SL-6107 regardless of theposition of the remote sw...

Page 6 - Test For Correct Common Wire Connection:

595-4514-13 -6- INSTALLATION Test For Correct Common Wire Connection: Re-install the switch. Turn the circuit breaker back on. Leaving the jumpered switch in one position, flip the other 3-way switch on and off. Lights turn on and off. Lights turn on and off. Jumper is correct. Go to next page. Flip...

Other Heath Zenith Models

All Heath Zenith Other