Field Controls UV-18X - Manual

Field Controls UV-18X

Field Controls UV-18X – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 4 – Bracket
  • Page 6 – Diagram A; Patent Pending 45°; BULB MOUNTING BRACKET SELECTION AND INSTALLATION; UV-AireTM Configurations; Diagram B; Installation
  • Page 7 – VI. REPLACEMENT PROCEDURE; Turn switch on unit to ‘OFF’ position and unplug unit from outlet.; VII. TROUBLESHOOTING GUIDE; MODEL
  • Page 8 – Limited Warranty
Loading the manual

UV-AIRE™ AIR PURIFYING SYSTEM

Model: UV-18X

READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION

LEAVE

THE

INSTALLATION

INSTRUCTIONS

WITH

THE

OWNER/OPERATOR

OF

THE

DEVICE

AFTER

OPENING

THE

CARTON,

UNPACK

AND

INSPECT

THE

UNIT

AND

LAMP

FOR

DAMAGE.

DO

NOT

INSTALL

THIS

UNIT

IF

ANY

DAMAGE

IS

NOTICEABLE.

SAFETY CONSIDERATIONS

WARNING:

Never expose eyes or skin to UVC light from any source.

Looking directly at the UVC light may cause permanent eye damage or blindness.

Never operate the UV-Aire™ Air Purifying System out of the plenum

.

Designed for a closed duct system. Do not mount near a return air opening

All duct openings in direct line of site of the UV light must be sealed with duct tape or equivalent sealing

methods.

WARNING: UV light will break down plastic materials not rated for UV exposure:
(Examples: wire insulation, flex duct, drain pans and humidifiers)

The unit must be mounted at least 30” from the above stated type of materials.

If it is necessary to mount the unit in direct line of site of these types of materials, they must be shielded

with aluminum foil, aluminum foil tape, or sheet metal.

WARNING: DO NOT mount this unit outdoors.

This product is designed for indoor installation only (i.e. attics, crawl spaces, basements, etc.).

ITEMS

INCLUDED

IN

KIT:

1-UV-Aire

power unit

4-Sheet metal mounting screws
2-Angled mounting brackets
2-Flat mounting brackets
1-Duct board mounting bracket
2-Ultra Violet lamps
1-Instruction Sheet
2-Wing nuts
Caution Labels
Gasket

UV-C light inhibits the growth and reproduction of germs and bacteria that circulate through a
homes’ heating and air conditioning system. The treatment is a safe, silent, and proven way
to make your home a healthier place to live.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - Bracket

Page 4 3. Remove base unit and cover from box. 4. Apply supplied “Duct Seal Kit” according to instructions included in kit. (See Figure 12) 5. Determine whether to use flat or angled bracket. (Refer to UV-Aire Configurations in Section III for aid in this decision) a. Flat Bracket Installation i. Re...

Page 6 - Diagram A; Patent Pending 45°; BULB MOUNTING BRACKET SELECTION AND INSTALLATION; UV-AireTM Configurations; Diagram B; Installation

Page 6 Diagram A Patent Pending 45° Installation Double Lamp (Angled Bracket) Angle option allows longer lamps to fit in smaller ducts. (16” Duct) IV. BULB MOUNTING BRACKET SELECTION AND INSTALLATION The UV-AIRE TM units come with an angled mounting bracket and flat mounting bracket to position the ...

Page 7 - VI. REPLACEMENT PROCEDURE; Turn switch on unit to ‘OFF’ position and unplug unit from outlet.; VII. TROUBLESHOOTING GUIDE; MODEL

Page 7 V. MAINTENANCE 1. Inspect and clean lamp at least every 6 months. 2. Replace your UV-Aire™ Air Purifying System lamp once a year to maintain the lamps maximum output intensity. The lamp should operate continuously for maximum lamp life and light effectiveness. VI. REPLACEMENT PROCEDURE VERY I...

Other Field Controls Models

All Field Controls Other