Field Controls S2000 - Manual
Field Controls S2000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SIMPLIFIED INSTALLATION INSTRUCTIONS; DETAILED INSTALLATION INSTRUCTIONS; INSULATE WATER TANK RESERVOIR; DO NOT INSTALL this unit in an attic period. Do Not; It is highly recommended but not required that the; MOUNTING TEMPLATE
- Page 3 – tightening the hex compression nut, tighten only enough to; CORRECT; CONDENSATE
- Page 4 – blower on the HVAC system does not operate when called; across the normally open contacts with the fan/blower running.; Heat Pump System and Steam Humidifier; We recommend our new Model APD switch.
- Page 5 – Field Controls Steam Humidifiers
- Page 6 – Copyright; Suitable locations
- Page 7 – RELATIVE HUMIDITY CHART; Installation instructions for the 072000 model; SETTING THE HUMIDISTAT; RH; Outside; Recommended Indoor; and up; Variable Speed WIRING DIAGRAM; Variable Speed Heat & Cool System and; capacities while operating.
- Page 8 – INITIAL START-UP * SEQUENCE OF OPERATION * SERVICE “LED” INDICATORS; blink rapidly during Maintenance mode.; SERVICE “LED” INDICATORS
- Page 9 – SERVICE INDICATORS; If necessary, fill the tank; LED LIGHT EXPLANATION; IMPORTANT NOTE; Steam Humidifier
- Page 10 – DO NOT cut off the grounded plug and/or; This will void the warranty.
- Page 11 – SERVICE AND REPLACEMENT PARTS
- Page 13 – Smart Digital Humidistat; Installation and Owner's Manual; down; The outdoor sensor is not required to; General Description; TECHNICAL BULLETIN; space. Field Controls recommends an
- Page 14 – APPLICATION NOTE; SUPPLEMENT TO THE; s job is to become the target of mineral attack, so it will be heavily
- Page 15 – DECORATIVE COVER
MODELS S2000 AND S2020
FOR GAS OR OIL FORCED AIR FURNACES, HEAT PUMPS AND ELECTRIC FURNACES
has been designed to be simple to Install, Operate and Maintain.
Read this manual before you install the Humidifier.
Parts included in the Steam Humidifier package are:
1. Self Piercing Saddle Valve
2. Installation Instructions and Owners Manual
3. Mounting Templates x2
4. Installation Hardware package
5. Insulation and tape
6. Automatic Drain Assembly
7. Humidistat - Model #062000 or 072000
8. 1/2” I.D. Drain Hose-8 FT.
9. Anode #Z100
Familiarizing yourself with the items listed in Figures 1
and 2 will assist you in installing and maintaining your
Steam Power Humidifier. This product should be installed
according to local and national codes and standards.
Options and additional parts recommended:
1. Water Hammer Arrester #WH 100
2. Anode #Z100
3. Decorative Under Duct Cover # SC100
4. Gasket Material to seal flanges (field provided)
5. Model APD Current Sensing Switch, Sail Switch or
other Airflow Proving Device.
6. WFA-195 Water Filter Assembly
WATER INLET
WATER LEVEL
PROBE
HEATER
TEMPERATURE PROBE
FIG. 1
For R
eplac
emen
t Part
s Ca
ll (80
0) 44
6-311
0
0902
1A01
18
U.S. P
ATEN
T NU
MBE
R 57
58 01
8
seria
l num
ber
Ewc
385 H
ighw
ay 33
, Eng
lishto
wn, N
J 077
26
CON
TRO
LS, I
NC.
UL
®
C
US
LIST
ED 1
41V
POW
ER
DRA
IN
FILL
HEAT
ER
BLO
WER
Therm
istor
Heate
r
Wate
r
Suita
ble fo
r Res
identi
al Us
e On
ly
Mode
l S20
20
Stea
m Hu
midifie
r
2.0 K
W 24
0 Volt
8.3 A
mps
FIG. 2
MANUAL WATER DRAIN
WATER PAN
TANK BAFFLE
BLOWER
INTERLOCK &
HUMIDISTAT CONN.
AUTO DRAIN CONN.
"T" ADAPTER
STATUS LIGHTS
OVERFLOW
FOR DRAIN
VALVE DETAILS
See Page 12
WATER INLET
This symbol on
the product means
the product is
listed by
Underwriters
Laboratories, Inc.
1
®
Copyright
©
2011 Field Controls All Rights Reserved.
The Residential Power Humidifier you have purchased
FIELD CONTROLS ELECTRONIC STEAM UNIT - POWER HUMIDIFIER
P/N 090375A0227 Rev. M
10/2011
&
Instructions
Owner's
Manual
Installation
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SIMPLIFIED INSTALLATION INSTRUCTIONS DETAILED INSTALLATION INSTRUCTIONS 1. Insulate the water reservoir. See figure 3. 2. Select the mounting location on the duct and tape on the mounting template. 3. Drill the (8) 1/8" mountings holes. 4. Cut out the humidifier opening in the duct. 5. Insert th...
6. WATER SUPPLY - Required Criteria 9. WIRING THE STEAM HUMIDIFIER 7. M OUNTING THE STEAM HUMIDIFIER 8. STEAM OPERATION - Required Criteria A. WATER SUPPLY USING THE SADDLE VALVE FURNISHED WITH UNIT. Important! See page 14. A. INSTALLING AND WIRING THE HUMIDISTAT B. OVERFLOW & DRAIN LINES - Requ...
Typi ca l Furnace S2000 & S2020 Humidifier Low Voltage Terminal Block G1 R G2 H H Heat only Thermostat W R G W R Heat Only System and Steam Humidifier with standard dry contact Humidistat Dry Contact Humidistat A A FIG. 6 Factory Jumper will stay in place unless a field installed Air Proving Dev...
