Field Controls CK-43 - Manual
Field Controls CK-43 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION INSTRUCTIONS; Fasten the flexible conduit from the SWG Venter into the conduit
- Page 3 – DRAFT CONTROL INSTALLATION; This draft control is; OLLAR; Figure 4
- Page 4 – B V; DO NOT use the supplied collar when mounting draft; ADJUSTMENTS; Vertical Flues Mounting -
- Page 5 – PROVING SWITCH ADJUSTMENTS; Failure to properly adjust the pressure switch as; THERMOSTAT HEAT ANTICIPATOR ADJUSTMENT; *Typical post purge time should be between 3 to 5 min.; WIRING; Disconnect electrical power
- Page 7 – INSTALLATION INFORMATION
2630 Airport Road · Kinston, NC 28504
Phone: 252-522-3031· Fax: 252-522-0214
www .fieldcontrols.com
24 VAC SYSTEM CONTROL KIT
Model: CK-43
The CK-43 is designed for use with the SWG Series Power
Venter for controlling Natural Gas and L.P. Gas Draft Induced
appliances.
Control kits control the operation of SWG Power Venters. Control
Kits can also control the operation of Field Draft Inducers and
Combustion Air Systems.
I
TEMS INCLUDED IN
K
IT
1) Junction box with mounted pressure switch and
relay/timer.
1) 1 Ft. Length of 1/4 inch aluminum tubing.
1) 1/4 inch tubing connector
1) Flexible conduit connector
1) 4" MG1 Barometric Draft Control or 5" AF Barometric
Draft Control
This device MUST be installed by a qualified agency in accordance with the manufacturers installation
instructions.
The definition of a qualified agency is:
any individual, firm, corporation or company which either in person or through a representative is
engaged in, and is responsible for, the installation and operation of gas appliances, who is experienced in such work, familiar with all
the precautions required, and has complied with the requirements of the authority having jurisdiction.
DO NOT DESTROY
THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT
Tubing
MG1 Barometric
Draft Control
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 INSTALLATION INSTRUCTIONS M OUNTING J UNCTION B OX The junction box can be mounted at the venter or remotely mounted away from the venter. (See Figure 1 & Figure 2) 1. Remove one of the knockouts from the side of the junction box where the pressure switch is mounted. Install the flexible ...
Page 3 DRAFT CONTROL INSTALLATION See Figure 4 for typical vent system layout. CAUTION: This draft control is shipped as a single acting draft control. If the draft control is not being used on a gas draft induced furnace, remove the gate stop on the draft control ring before installing. C OLLAR I N...
Page 4 D RAFT C ONTROL I NSTALLATION IN T YPE B V ENT P IPE CAUTION: DO NOT use the supplied collar when mounting draft control to Type B Vent Pipe. Install by using a Type B Vent Pipe Tee. 1. Install a vent pipe reducer or increaser into the inner pipe and fasten using sheet metal screws. (See Figu...
