Fanimation TW206 - User Manual

TW206 Wall Control

SPECIFICATION and INSTRUCTION SHEET

FAN MODEL USED:

See Catalog or visit our website

www.fanimation.com

for more

information

How to Wire and Operate Your TW206 Wall Control

DESCRIPTION:

One DC Motor Ceiling Fan and Light, Variable Speed, Reversing Remote

Control

NOTE: If fan or supply wires are different colors than indicated,

have this unit installed by a qualified electrician.

WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advise, as it must be

grounded for safe operation.

BARE

WARNING

Check to see that all connections are tight, including ground,

and that no bare wire is visible at the wire connectors,

except for the ground wire. Do not operate fan until the

blades is in place. Noise and fan damage could result.

AC120V 60HZ

INPUT

WHITE (AC IN N)

AC SUPPLY

BLACK (AC IN L)

BLACK

BLACK

WHITE

NE

E

R

G

L

O

RT

N

O

C

LL

A

W

BLACK (TO MOTOR L)

K

C

AL

B

K

C

AL

B

)L

NI

C

A(

K

C

AL

B

E

RI

W

D

N

U

O

R

G

Figure 1

Figure 2

Figure 3

1. Installing Wall Control

(Figure 1):

• With electrical power still disconnected, remove the

existing wall plate and switch.

• Make wiring connections with wire nuts as shown in

Figure 1.

– One black wire from wall control unit to black

(TO MOTOR L).

– One black wire from wall control unit to black wire

leading to ceiling outlet box.

– One green wire from wall control unit to ground wire

leading to ceiling outlet box.

• Restore electrical power.

2.

• Attach wall control unit to outlet box using the two

two screws provided.

•Attach wall plate to the switch control. (Figure 2)

Dip Switch

O D

Set

4. Remote Control Setting and Speed (RPM) Setting

Process : (Figure 3)

1) When powering on your fan, do not press any

button(s) before pressing the “SET” button,

otherwise it will fail the learn procedure. If you press

a button before the “Set” button, please turn the

power off then on again, and start the process again.

2) After installing the unit and restoring power to

your fan, press and hold the “SET” button 1-5

seconds. You must press the “SET” button within 30

seconds of restoring power to the fan.

3) When press the “SET” button the fan will make

one musical sound and start to run to begin the control

setting process.

4) DO NOT press any button(s) after pressing the SET

button and while the fan is programming or it will fail

to program. The fan will run in both directions for a

total of approximately 5 minutes.

5) When the fan stops after approximately 5 minutes

the fan will make two musical sounds that mean the

control and speed setting process is complete. The fan

is now ready for normal use.

NOTE: If you want to change the blades: turn

the power off→ change the blades→ turn the

power on→ perform the control setting process.