Fanimation CW2WH - User Manual
Fanimation CW2WH Remote Control – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
CW2(C2) Wall Control
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION:
3 Wire Control One Ceiling Fan & Light, 3 Fan Speed &
3 Light-Slide Control
ELECTRICAL SPECS:
120 Volts, 60 Hertz, Max. Fan Load 1.25 amps,
Light Rating 190W Incandescent, 4 Wire Installation
FAN MODELS USED:
most Fanimation fans - see Catalog or visit our website,
www.fanimation.com for more information
How to Wire and Operate Your CW2(C2) Wall Control
NOTE:
If fan or supply wires are different colors than indi-
cated, have this unit installed by a qualified electrician.
1.
Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Set the knob and light switch of the wall control in the
off (0) position.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black wire from wall control unit to black
(A.C. power supply).
– One blue wire from wall control unit to blue
(light).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green/yellow wire from wall control unit to green
ground wire.
• Attach wall control unit to outlet box using the two
screws provided. Then, the face plate attaches the wall
control. (Figure 2)
• Restore electrical power.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
WARNING
To avoid possible
fire
or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
WARNING
Figure 1
Figure 2
NOTE:
Supply wires and fan wires
omitted for clarity.
2.
Operating & Using Wall Control:
NOTE:
Set pull chain to high speed and light kit at power
on before using the wall control. You can now use your
speed control to select any of the 3-speeds plus OFF.
• 3 Slide Switch – low light
• 2 Slide Switch – medium light
• 1 Slide Switch – bright light
• 0 Slide Switch – light off
Copyright 2010 Fanimation
2010/01
10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055 •
FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website @ www.fanimation.com
• 3 Slide Switch – low fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – high fan speed
• 0 Slide Switch – fan off
BLACK
BLACK (AC IN)
2
0
1
3
SOURCE
SUPPLY
120V AC
BLUE
BLACK (TO FAN)
GREEN/YELLOW (GROUND)
BLUE (TO LIGHT)
WHITE
GREEN
GROUND
BLACK
WHITE
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
