Fanimation CW5WH - User Manual

Fanimation CW5WH

Fanimation CW5WH Remote Control – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
Page: / 3
Loading the manual

WARNING

To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.

WARNING

To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.

WARNING

Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.

1.

Installing Wall Control (Figures 1 & 2):

• With electrical power still disconnected, remove
the existing wall plate and switch.
• Set the knob and light switch of the wall control in
the off (0) position.
• Make wiring connections with wire nuts as shown
in Figure 1.
– One black wire from wall control unit to black
(A.C. power supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green/yellow wire from wall control unit to
green ground wire.
• Attach wall control unit to outlet box using the two
screws provided. Then, the face plate attaches the
wall control. (Figure 2)
• Restore electrical power.

2.

Set the fan speed of pull chain fans to high with

the pull chain before using the wall control.

NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.

Figure 1

Figure 2

Figure 3

CW5 (C5) Wall Control

SPECIFICATION and INSTRUCTION SHEET

DESCRIPTION:

Two Fan (no light) Only, 3 Speed-Slide Control

ELECTRICAL SPECS:

120 Volts, 60 Hertz, 5 amps, 3 Wire Installation

FAN MODELS USED:

most Fanimation fans - see catalog or visit our website, fanimation.com for

more information

How to Wire and Operate Your CW5 (C5) Wall Control

Copyright 2020 Fanimation

2020/12 V.01

10983 Bennett Parkway

Zionsville, IN 46077

(888) 567-2055 • FAX (866) 482-5215

Outside U.S. call (317) 733-4113

WWW.FANIMATION.COM

NOTE: Supply wires and fan wires
omitted for clarity.

1

0

2

3

GREEN

120V AC SUPPLY SOURCE

WHITE

BLACK

BLACK

GREEN

/YELLOW (GROUND)

BLK

(AC IN)

BLK

(TO FAN)

WHITE

GROUND

GREEN

WHITE

BLACK

Face Plate

Screw

Outlet Box

3.

Operating Wall Control: (Figure 3)

• 3 Slide Switch – low fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – high fan speed
• 0 Slide Switch – fan off

1

0

2

3

1

0

2

3

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Fanimation Remote Controls Models

All Fanimation Remote Controls