Fanimation CW7WH - User Manual
Fanimation CW7WH Remote Control – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
1.
Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black wire from wall control unit to black (hot
supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
• Attach wall control unit to outlet box using the two
screws provided. Then, the face plate attaches the
wall control. (Figure 2)
• Restore electrical power.
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
Figure 1
Figure 2
CW7WH Wall Control
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION:
Five Fans (no light) Only, 3 Speed-Slide Control
ELECTRICAL SPECS:
5A, 120V, 60Hz Ceiling Fan
FAN MODELS USED:
most Fanimation fans - see catalog or visit our website, fanimation.com for
more information
How to Wire and Operate Your Wall Control
Copyright 2020 Fanimation
2020/12 V.01
10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
WWW.FANIMATION.COM
NOTE: Supply wires and fan wires
omitted for clarity.
Face Plate
Screw
Outlet Box
1
0
2
3
BLK
TO HOT
GRN from hanger ball
GRN from bracket
120 VAC SUPPLY
(User Supplied)
WH-
TO MO
TOR
BLK-
TO MO
TOR
BLUE-Not Used
BLK
TO FAN
BLK
WH
GRN
GRN from hanger ball
GRN from bracket
WH-
TO MO
TOR
BLK-
TO MO
TOR
BLUE-Not Used
GRN from hanger ball
GRN from bracket
WH-
TO MO
TOR
BLK-
TO MO
TOR
BLUE-Not Used
GRN from hanger ball
GRN from bracket
WH-
TO MO
TOR
BLK-
TO MO
TOR
BLUE-Not Used
GRN from hanger ball
GRN from bracket
WH-
TO MO
TOR
BLK-
TO MO
TOR
BLUE-Not Used
3.
Operating Wall Control:
• 3 Slide Switch – low fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – high fan speed
• OFF Switch – fan off
2.
Set the fan speed of pull chain fans to high with
the pull chain before using the wall control.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
