Fanimation CW6WH - User Manual
Fanimation CW6WH Remote Control – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
1.
Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove
the existing wall plate and switch.
• Set the knob and light switch of the wall control in
the off (0) position.
• Make wiring connections with wire nuts as shown
in Figure 1.
– One black wire from wall control unit to black
(A.C. power supply).
– One blue wire from wall control unit to blue (light).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green/yellow wire from wall control unit to
green ground wire.
• Attach wall control unit to outlet box using the two
screws provided. Then, the face plate attaches the
wall control. (Figure 2)
• Restore electrical power.
2.
Set the fan speed and light of pull chain fans to
high with the pull chain before using the wall control.
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
Figure 1
Figure 2
Figure 3
CW6 (C6) Wall Control
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION:
3 Wire Control One Ceiling Fan & Light, 2 Fan Speed & 3 Light-Slide Control
ELECTRICAL SPECS:
120 Volts, 60 Hertz, Max. Fan Load 5 amps,
Light Load 500W Incandescent, 4 Wire Installation
FAN MODELS USED:
• The Palisade • The Caruso
How to Wire and Operate Your CW6 (C6) Wall Control
Copyright 2020 Fanimation
2020/12 V.01
10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
WWW.FANIMATION.COM
NOTE: Supply wires and fan wires
omitted for clarity.
2
0
1
3
Face Plate
Screw
Outlet Box
3.
Operating Wall Control: (Figure 3)
120V AC
SUPPLY
SOURCE
BLACK
BLACK
BLUE
BLACK (AC IN)
BLUE (TO LIGHT)
BLACK (TO FAN)
GREEN/YELLOW (GROUND)
WHITE
WHITE
GROUND
GREEN
Light Control
• 3 Slide Switch – low light
• 2 Slide Switch – medium light
• 1 Slide Switch – bright light
• 0 Slide Switch – light off
Fan Control
• 0 Slide Switch – fan off
• L Slide Switch – low fan speed
• H Slide Switch – high fan speed
• 0 Slide Switch – fan off
2
0
1
3
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
