Elica EMG636S1 - User Manual

Page 3 - ENGLISH; Contents; Save these Instructions for the Local Electrical Inspector’s use.

3 ENGLISH Contents Important safety notice................................................................................................................................................................................................. 4 Electrical & installation requirements ......................

Page 4 - IMPORTANT SAFETY NOTICE

4 I IMPORTANT SAFETY NOTICE I CAUTION FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPOURS. I WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, ORINJURY TO PERSONS, OBSERVE THE FOLLOWING:A. Use this unit only in the manner intended by the manufacturer...

Page 5 - ELECTRICAL & INSTALLATION REQUIREMENTS; IMPORTANT; DIMENSIONS AND CLEARANCES; Models

5 ELECTRICAL & INSTALLATION REQUIREMENTS IMPORTANT Observe all governing codes and ordinances. It is the customer’s responsibility: đƫ To contact a qualiﬁed electrical installer. đƫ To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA...

Page 6 - LIST OF MATERIALS; CAUTION

6 LIST OF MATERIALS Removing the packaging. I CAUTION Remove carton carefully, Wear gloves to protect against sharp edges. I WARNING Remove the protective ﬁlm covering the product before putting into operation. Supplied Part Pieces Supplied Part Pieces Hood assembly with blower and LED lamps already...

Page 7 - Ducting options; Ducting version; Preparation; Installation; Ceiling support structures; đƫ

7 Ducting options Closely follow the instructions set out in this manual.All responsability, for any eventual inconveniences, damages or ﬁres caused by not complying with the instructions in thismanual, is declined. Ducting version Ductless (Recirculating) The hood is equipped with a 6” (15.2 cm) ro...

Page 8 - Example B; Example C

8 Example B 2 x 4 cross framing Align duct to center of cooktop Hood front Cooktop outline NOTE: Top view ceiling joists parallel to front of hood 10 1 ⁄ 16 ” (25.5 cm) install cross- framing symmetrically over duct/cooktop Centerline Ø 6” (15.9v cm) duct 7 1 ⁄ 16 ” (17.9cm) 16” (40.6 cm) joist spac...

Page 9 - Install the lower horizontal support with 8 - 4.2 x 8 mm; Install the 4 vertical supports with 16 - 4.2 x 8 mm screws.; Using 2 or more people, lift the range hood assembly

9 5 Install the lower horizontal support with 8 - 4.2 x 8 mm screws. A. Lower horizontal supportB. 8 - 4.2 x 8 mm screws B A 6 Install the 4 vertical supports with 16 - 4.2 x 8 mm screws. A. 4- Upper vertical supportsB. 16 - 4.2 x 8 mm screws B A 7 Install the structure to the horizontal support wit...

Page 10 - Install the 4 vertical supports with 16 - 4.2x8 mm screws.

10 9 Attach the range hood assembly to the lower vertical supports with 2 leveling screws. A. 2 - Leveling screws B. Lower vertical support C. Place leveling screws through the structure A B C 10 Install the 4 vertical supports with 16 - 4.2x8 mm screws. Check everything is tightly screwed. A. 4 - L...

Page 11 - Electrical connection; WARNING; Complete the installation; ONLY FOR RECIRCULATING VERSION; Air deflector installation

11 Electrical connection I WARNING TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT WORK.ELECTRICAL SHOCK HAZARD. I WARNING TURN OFF POWER CIRCUIT AT THE SERVICE PANEL BEFORE WIRING THIS UNIT.120 VAC, 15 OR 20 AMP CIRCUIT REQUIRED. đƫ Facing the front of the range hood, remove the left knockout and t...

Page 12 - Duct cover installation (both ducted and non ducted versions)

12 đƫ Measure from the bottom of the air deﬂector to the bottom of the hood outlet, as shown. A A. Dimension to measure đƫ Cut the duct at the measured size. đƫ Slip the duct onto the bottom of the deﬂector. đƫ Place the duct over the exhaust outlet from the hood. đƫ Use duct tape to seal the deﬂect...

Page 13 - Description of the hood; Blower and LED lamp controls

13 đƫ Secure the lower duct cover to the range hood canopy using 4 - 4.2 x 8 mm screws. A A. 4 - 4.2x8 mm screws Description of the hood 1 2 3 4 5 6 1. Blower and LED lamp controls 2. LED lamps 3. Grease ﬁlter handle4. Grease ﬁlters 5. Lower duct cover6. Upper duct cover

Page 14 - Control; CFM Reduction System

14 Control 1 2 3 4 5 6 1. Button ON/OFF motor (stand by) 2. Button for low speed (suction power) selection When ﬂashing, it indicates that you must wash the grease ﬁlter. 3. Button for medium speed (suction power) selection 4. Button for high speed (suction power) selection 5. Button for intensive s...

Page 15 - Maintenance; Cleaning; Grease Filter; Replacing a LED Lamp; The charcoal filters cannot be cleaned. It should be

15 Maintenance I ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cle...

Page 16 - ELICA North America; TWO-YEAR LIMITED WARRANTY; TO OBTAIN SERVICE UNDER WARRANTY; Damage or failure to the product caused by operator abuse.; WHO IS COVERED

16 ELICA North America TWO-YEAR LIMITED WARRANTY TO OBTAIN SERVICE UNDER WARRANTY Owner must present proof of original purchase date. Please keep a copy of your dated proof of purchase (sales slip) in order to obtain service under warranty. PARTS AND SERVICE WARRANTY For the period of two (2) years ...

Elica EMG636S1 - User Manual

Table of Contents:

Summary

Other Elica Range Hoods Models