Crimestopper EZ-3 - Manual
Crimestopper EZ-3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – VENDORS
- Page 3 – USING THE REMOTE TRANSMITTER; SLIDE COVER
- Page 4 – REMOTE ENGINE STARTING - SUCCESSFUL START:; IGN
- Page 5 – REMOTE ENGINE CONTROL; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:; now controlling your vehicle.
- Page 7 – INFINITY RUN MODE; INDEFINITELY after the programmed run time elapses
- Page 9 – SETTING THE TURBO TIMER RUN TIME; REMOVE KEY
- Page 10 – CONVENIENCE AND SAFETY FEATURES
- Page 11 – HOOD OPEN SAFETY (Requires hood pin switch)
- Page 12 – TRANSMITTER PROGRAMMING
- Page 13 – FLASH LIGHT; A single Remote Control can control two different vehicles.
- Page 15 – BATTERY REPLACEMENT; To replace the battery:; Screws
EZ-3 and EZ-4
1-WAY REMOTE START SYSTEM
OPERATING INSTRUCTIONS
CONGRATULATIONS
on your choice of a Cool Start
™ Remote Engine Starter and Keyless Entry with DP
Technology by Crimestopper Security Products Inc.
This booklet contains the information necessary for operating
your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, and Brake Reset. For programming, the hood pin and program button are
required.
-OPTIONAL:
These features are to be connected only if desired or agreed upon by the customer and the installing
dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features may also
require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is going to be
installed with your particular system.
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV 09-2008
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………….….…………2 Using the Remote Transmitter………………………………………………………………………….………....…….3 Status LED……………………………………………………………………………………………….……….……….4 Remote Engine Control…………….…..……………………………………………………………….…….……….4-7 Turbo Timer Mo...
3 USING THE REMOTE TRANSMITTER SLIDE COVER UP DOWN FLASHLIGHT 2nd VEHICLE For RS-3DP II The transmitter supplied with this system has 3 buttons, a flashlight and a car 2 side button. The button configuration is Factory-set and unchangeable. See Page 13 for additional information on how to use your r...
4 STATUS LED LED Operation: (Optional, requires Installation of LED) LED will flash when locking your doors with remote. LED will remain solid in Valet Service Mode. REMOTE ENGINE CONTROL Remote Start & Auxiliary Output – Button Press Selection (Option # 6): To eliminate the possibility of accid...
