Crimestopper EZ-3 - Manuals

Page 2 - VENDORS

2 TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………….….…………2 Using the Remote Transmitter………………………………………………………………………….………....…….3 Status LED……………………………………………………………………………………………….……….……….4 Remote Engine Control…………….…..……………………………………………………………….…….……….4-7 Turbo Timer Mo...

Page 3 - USING THE REMOTE TRANSMITTER; SLIDE COVER

3 USING THE REMOTE TRANSMITTER SLIDE COVER UP DOWN FLASHLIGHT 2nd VEHICLE For RS-3DP II The transmitter supplied with this system has 3 buttons, a flashlight and a car 2 side button. The button configuration is Factory-set and unchangeable. See Page 13 for additional information on how to use your r...

Page 4 - REMOTE ENGINE STARTING - SUCCESSFUL START:; IGN

4 STATUS LED LED Operation: (Optional, requires Installation of LED) LED will flash when locking your doors with remote. LED will remain solid in Valet Service Mode. REMOTE ENGINE CONTROL Remote Start & Auxiliary Output – Button Press Selection (Option # 6): To eliminate the possibility of accid...

Page 5 - REMOTE ENGINE CONTROL; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:; now controlling your vehicle.

5 REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting engines, the unit will allow a starter crank time...

Page 7 - INFINITY RUN MODE; INDEFINITELY after the programmed run time elapses

7 REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated with "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses . This mode will allow the vehicle to be left running and unattended with...

Page 9 - SETTING THE TURBO TIMER RUN TIME; REMOVE KEY

9 SETTING THE TURBO TIMER RUN TIME REMOVE KEY PRESS TURBO FLASH 1-5X EXIT VEH. PRESS AND HOLD BRAKE TIMER BUTTON 1-5 TIMES RUNNING RELEASE BRAKE LIGHTS RUNNING REMAIN 1-5 MIN.

Page 10 - CONVENIENCE AND SAFETY FEATURES

10 CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to instal...

Page 11 - HOOD OPEN SAFETY (Requires hood pin switch)

11 CONVENIENCE AND SAFETY FEATURES VALET MODE / REMOTE START DISABLE (Requires Installation of Valet Switch) Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into Valet Mode. The remote start function W ILL NOT operate when in Valet Mode. To enter Valet...

Page 12 - TRANSMITTER PROGRAMMING

12 TRANSMITTER PROGRAMMING Note: All transmitter codes must be learned at time of programming!! The RS-4 learns up to 4 different transmitter codes. 1. Turn key to the ON position. (Pink wire must be connected.) 2. Press Programming button 4 times, then after a few seconds the unit flashes the parki...

Page 13 - FLASH LIGHT; A single Remote Control can control two different vehicles.

13 VEHICLE #2 Press side button first, then you have 4 seconds to control vehicle #2. FLASH LIGHT 2-VEHICLE OPERATION & PROGRAMMING A single Remote Control can control two different vehicles. SETUP: Follow the “Transmitter Programming” steps on the second vehicle below. Program Car #2’s existing...

Page 15 - BATTERY REPLACEMENT; To replace the battery:; Screws

15 BATTERY REPLACEMENT To replace the battery: Simply remove the 3 screws on back of the transmitter and open the case. Remove the battery and replace. The replacement battery is GP23A. 3 Screws Remove