Crimestopper CS-882 - Manual
Crimestopper CS-882 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – COMPONENT MOUNTING; Mount in a visible location on the dashboard or console.; WIRING; NORMALLY OPEN; BLACK WIRE: SYSTEM CHASSIS GROUND
- Page 3 – YELLOW WIRE: +12 VOLTS IGNITION SWITCHED; Connect to door pin activation circuit in vehicle:
- Page 4 – **SEE DOOR LOCK MOTOR / VALIDATION WIR E CONNECTIONS NEXT PAGE; BLACK Wire: Sensor Ground; RED Wire Sensor +12V Power
- Page 5 – CURRENT SENSING; DO NOT; Remaining side of resistor connects to band end of 2
- Page 6 – POSITIVE VALIDATION INPUTS; The CS-882OEM system will NOT ARM if a NEGATIVE
- Page 7 – PROGRAMMABLE OPTIONS; OPTIONS CHART
- Page 8 – OPERATION; ARMING
- Page 9 – VALET MODE
- Page 10 – WIRING DIAGRAM; OEM
CS-882 OEM
ALARM UPGRADE FOR FACTORY KEYLESS ENTRY
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of an Alarm Upgrade System by Crimestopper Security Products Inc.
This booklet contains the information necessary for installing, using, and maintaining this system. If any
questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support
number below.
*IMPORTANT INFORMATION:
This system does not improve or affect the range of the factory remote keyless entry transmitters.
This is an ADD-ON system only. The arm/disarm range of this system will be identical to that of the
Factory Keyless System’s lock/unlock range.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
REV. A 8/2002 SW: PG30500030CT1
INSTALLATION PRECAUTIONS & WARNINGS
BEFORE BEGINNING
, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR
BAGS, ABS BRAKES, BATTERY, ETC.).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED
with brake, and gas pedals, steering
column, or any other moving parts in the vehicle.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
COMPONENT MOUNTING Control Unit: DO NOT mount or wiring harness where they can become entangled with moving parts such as brake/gas/clutch pedals, or the steering column! The control module should be mounted in a concealed location. Do not mount the control unit in the engine compartment. LED: Mount...
WIRING ORANGE WIRE: (-) NEGATIVE STARTER DISABLE (Armed output) Ground output when system is armed. This output is used for disabling the starter or to activate other optional devices such as scanner LED’s, window control modules, voice modules etc. For starter kill, cut starter wire and connect bet...
WIRING GREEN WIRE: (-) HOOD/TRUNK TRIGGER Connect this wire to a grounding hood / trunk pin switch or to existing factory hood and trunk pin switches that read ground when open. If no existing switches are available, new pin switches may be installed. Note: DO NOT mount new pin switches in water pat...
