Crimestopper CS-882 - Manuals

Page 2 - COMPONENT MOUNTING; Mount in a visible location on the dashboard or console.; WIRING; NORMALLY OPEN; BLACK WIRE: SYSTEM CHASSIS GROUND

COMPONENT MOUNTING Control Unit: DO NOT mount or wiring harness where they can become entangled with moving parts such as brake/gas/clutch pedals, or the steering column! The control module should be mounted in a concealed location. Do not mount the control unit in the engine compartment. LED: Mount...

Page 3 - YELLOW WIRE: +12 VOLTS IGNITION SWITCHED; Connect to door pin activation circuit in vehicle:

WIRING ORANGE WIRE: (-) NEGATIVE STARTER DISABLE (Armed output) Ground output when system is armed. This output is used for disabling the starter or to activate other optional devices such as scanner LED’s, window control modules, voice modules etc. For starter kill, cut starter wire and connect bet...

Page 4 - **SEE DOOR LOCK MOTOR / VALIDATION WIR E CONNECTIONS NEXT PAGE; BLACK Wire: Sensor Ground; RED Wire Sensor +12V Power

WIRING GREEN WIRE: (-) HOOD/TRUNK TRIGGER Connect this wire to a grounding hood / trunk pin switch or to existing factory hood and trunk pin switches that read ground when open. If no existing switches are available, new pin switches may be installed. Note: DO NOT mount new pin switches in water pat...

Page 5 - CURRENT SENSING; DO NOT; Remaining side of resistor connects to band end of 2

4 ON CURRENT SENSING DIP SWITCH #4 OFF CURRENT SENSING The CS-882OEM system includes a current sensing circuit to monitor current flow through the vehicles electrical system. If an intruder opens a door and the interior lights turn on, the CS-882 system will detect a current drain and trigger the al...

Page 6 - POSITIVE VALIDATION INPUTS; The CS-882OEM system will NOT ARM if a NEGATIVE

2 3 1 4 ON NEGATIVE VALIDATION INPUTS (TOP EDGE OF 882 MODULE) 2 3 1 4 ON POSITIVE VALIDATION INPUTS (TOP EDGE OF 882 MODULE) DOOR / LOCK & VALIDATION WIRES (TYPICAL INSTALLATION) VALIDATION WIRES ON (MODE A = DIP SWITCHES 1-3 ON): The Validation wires serve as a secondary input to prevent the s...

Page 7 - PROGRAMMABLE OPTIONS; OPTIONS CHART

PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 7 times within 10 seconds. 2. Turn OFF Ignition. LED will flash slowly once per second as and indicator the system is in programming mode. 3. Within 20 seconds, press the Override/Program button the number of times th...

Page 8 - OPERATION; ARMING

OPERATION ARMING To arm the alarm and lock the doors, press the Lock button of your Factory Keyless Remote Control. The 882 OEM system will sense the Door Lock signal and Arm. The lights will flash once, the vehicle horn or siren will chirp once. After 3 seconds, the LED indicator will begin flashin...

Page 9 - VALET MODE

OPERATION VALET MODE To disable alarm functions of the 882 system, turn the Ignition ON and press the override/program button 3 times within 8 seconds. After 8 seconds, the dash LED turns on solid as an indicator that the system is in valet mode. Repeat this steps to exit VALET mode. The LED wi ll g...

Page 10 - WIRING DIAGRAM; OEM

WIRING DIAGRAM VALET/ IGN SW. STARTER STATUS LED FUSE BOX IGNITION ON &CRANKING VOLTAGE STARTER WIRE 85 87A CUT 86 3 0 RED VIOLET BLACK WHITE/RED (-) ARMED OUTPUT(STARTER DISABLE) IGN SW. ORANGE WHITE FUSE 15A PARKING LIGHTS SHOCK SENSOR BATTERY CS-882 OEM PROGRAM BUTTON + IMMOBILIZE (Low-Curren...