Crimestopper CS-2001 - Manual
Crimestopper CS-2001 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; CONTROL MODULE MOUNTING; Driver’s Side underdash
- Page 3 – COMPONENT MOUNTING; Mount the red; LED; firewall or side paneling.; WIRING; BLACK WIRE: SYSTEM CHASSIS GROUND
- Page 4 – Connect to RED siren wire.; BLACK WIRE SENSOR GROUND; RED WIRE SENSOR +12V POWER
- Page 5 – POWER DOOR LOCK WIRING; +12V Coil Power for external relays TERM 86.; DETERMINING DOOR LOCK TYPE:; Many GM Some Chrysler; One wire dual voltage:; Some Nissan Subaru; Electric vacuum pump:; NEGATIVE TRIGGER DOORLOCK WIRING
- Page 6 – DIP SWITCH PROGRAMMING; AFTERMARKET MOTOR/DOOR LOCK WIRING
- Page 7 – PROGRAMMING; ELECTRONIC PROGRAMMABLE OPTIONS; PROGRAMMING OPTIONS CHART; DOUBLE UNLOCK PULSE
- Page 8 – PASSIVE CARJACK; System can learn up to 3 different codes max.; The system is now in programming mode.
- Page 9 – OPERATION; BUTTON REMOTE TRANSMITTER:; ACTIVE ARMING
- Page 10 – PRE-WARNING SHOCK PROTECTION; THROUGH THE TRANSMITTER; PASSIVE ARMING / PASSIVE LOCK MODES
- Page 11 – DEFECTIVE ZONE ALERT/BYPASS; Doors; VEHICLE CONTROL; CARJACK PROTECTION; ACTIVE CARJACK
CS-2001
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of a Gargoyle
™ Remote Alarm System by Crimestopper Security
Products Inc.
This booklet contains the information necessary for installing, using, and maintaining your alarm
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the
Tech Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Siren,
L.E.D., Power, Ground, Doorpin, etc.
-OPTIONAL:
These are features to be connected only if desired or agreed upon by the installing dealer (i.e.
Door Locks, Flashing Lights, Starter Kill, Hood, Trunk, and Auxiliary Remote Outputs etc.)
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUS...
COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible lo...
WIRING BROWN WIRE: (+) SIREN OUTPUT (2 Amp Max.) Connect to RED siren wire. BLUE WIRE: (-) HOOD/TRUNK TRIGGER This wire is an input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches that read ground when open. If no existing switches are available, ins...
