Crimestopper CS-2011DP - Manual
Crimestopper CS-2011DP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; OPERATION CAUTIONS & WARNINGS; and its
- Page 3 – REMOTE OPERATION QUICK GUIDE; *NEW* Double Button Press for Remote start and Trunk release:
- Page 4 – OPERATING INSTRUCTIONS - ALARM; Alarm Triggering
- Page 5 – Remote Panic Protection
- Page 6 – Valet Mode (Enter manually or using the remote)
- Page 7 – Shock Sensor = 1 Flash; REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START; be turned off with remote transmitter.
- Page 8 – REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:; IGN; REMOTE ENGINE STARTING - UNSUCCESSFUL START; and 3; time. For hard starting engines, the unit will allow a starter crank; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:
- Page 9 – ENTERING YOUR REMOTE STARTED VEHICLE:; is now controlling your vehicle.; ENTERING A VEHICLE DURING “IDLE-DOWN” or “INFINITY RUN” MODES:; See “ENTERING YOUR REMOTE STARTED VEHICLE” section above.
- Page 10 – INFINITY RUN MODE; This mode allows the vehicle’s engine to remain running; INFINITY RUN MODE – EXITING THE VEHICLE:; See “ENTERING YOUR REMOTE STARTED VEHICLE” section at top of page 8.
- Page 11 – TIMED SELF START MODE; confirmation that the unit is in Timed Self-Start Mode.; RESETTING TIMED SELF START MODE
- Page 12 – OPTIONAL TURBO TIMER MODE; OPTIONAL TURBO TIMER MODE:; should remain running for the selected number of minutes.; REMOVE KEY
- Page 13 – ANTI CARJACK PROTECTION; REMOTE OPERATED CARJACK PROTECTION
- Page 14 – TRANSMITTER PROGRAMMING; learn. Now the unit is waiting for a 2; code, so repeat this step as needed with up to 3 additional remotes.; code, 3 flashes for the 3; mode, otherwise turn key OFF and close the hood.; WAIT FOR
- Page 15 – TROUBLESHOOTING: “BEFORE YOU CALL SECTION”; SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS:
CS-2011DP
DP Series (Data Port)
Super Rage™
Remote Control Alarm & Remote Engine Starting System
OPERATION INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of a Super Rage
™ Alarm & Remote Engine Starter with DP Technology
by Crimestopper Security Products Inc.
This booklet contains the information necessary for operating your
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Power,
Ground, Lights, Siren, etc.
-OPTIONAL:
Optional features are connected only if desired or agreed upon by the installing dealer i.e. Door
Locks, Horn Honk, Dome light illumination, Starter Kill, L.E.D., Trunk Pop, etc. These features may require
additional parts and labor charges. Consult with your installer about these features
before
installation.
CONTACT INFORMATION:
TECHNICAL SUPPORT (800)-998-6880
Monday - Friday 8:00am - 4:30pm Pacific
Website: www.crimestopper.com
E-mail: [email protected]
CRIMESTOPPER
SECURITY PRODUCTS, INC.
1770 S. TAPO STREET
SIMI VALLEY, CA. 93063
REV.B 1.10.2006
This device complies with FCC Rules part 15. Operation is subject
to the following two conditions: 1) This device may not cause
interference, and (2) this device must accept any interference that
may be received, including interference that may cause undesired
operation. The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modification to this
equipment. Such modification could void the user's authority to
operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 TABLE OF CONTENTS Operation Cautions & Warnings……..………..……………….…………………………………………….………..…2 Quick Guide……………………………...………………………………………………………………………………...3 Operating Instructions - Alarm…………………………………….………………….………..……………..…….....4-7 LED Diagnostics………………..……………………………….…………………………………….………..……...….7 Remo...
3 REMOTE OPERATION QUICK GUIDE START LOCK UNLOCK REMOTE #4 #3 #2 #1 2ND VEHICLE TRUNK (AUX#3) (AUX#2) (AUX#4) STARTER #5 CRIMESTOPPER NOTE: BUTTON #3 and #4 Remote Start/Trunk There is a deliberate delay or 2 presses (Optional) built into the system on button #4 and #3 to help prevent accidental rem...
4 OPERATING INSTRUCTIONS - ALARM Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The System will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. After a ...
