Crimestopper RS800 - Manual
Crimestopper RS800 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION CAUTIONS & WARNINGS; parts in the vehicle.; DO NOT; result in damage to the unit not covered under warranty.; DO NOT; WIRING INSTRUCTIONS
- Page 5 – IGNITION SWITCH WIRING
- Page 6 – POWER DOOR LOCK WIRING; PIN DOOR LOCK PLUG:; +12V Coil Power for external relays TERM 86.; DETERMINING DOOR LOCK TYPE:; Many GM Some Chrysler; One wire dual voltage:; Some Nissan Subaru; Electric vacuum pump:; NEGATIVE TRIGGER DOORLOCK WIRING
- Page 7 – IMPROVED “SMART” TACHLESS MODE; SMART TACHLESS JUMPERS: (Remove Access Door on top of module)
- Page 8 – Tach Reference Mode; These Tach Signal locations mentioned are provided as a
- Page 9 – TRANSMITTER PROGRAMMING; Transmitter Code Learning:; code and
- Page 10 – OPTION PROGRAMMING
- Page 11 – REMOTE START TROUBLESHOOTING; UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START:
- Page 12 – NOTE: USE EXTERNAL RELAYS FOR HIGH-CURRENT; ACC or IGN2; BATTERY; Series II
RS800
Series
II
Remote Engine Starting System
INSTALLATION INSTRUCTIONS
PRE-INSTALLATION CONSIDERATIONS
To ease and reduce installation time, we suggest you READ THIS MANUAL and consider the following points before
beginning your installation:
BEFORE BEGINNING,
check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS,
ABS BRAKES, ENGINE / BODY COMPUTER AND BATTERY).
PLAN OUT YOUR INSTALLATION
and determine most suitable locations for all components to be placed. These
components include: The module itself, valet/program button, possible extra relays, and antenna/receiver.
DAMAGE
resulting from incorrect installation or failure to follow guidelines stated in this book will not be covered under
warranty and subject to repair or replacement charges.
USE A VOLT/OHM METER
to test and locate all connections. Test Lights can damage a vehicle’s computer systems.
Record all color codes of vehicle wiring to be used for reference. This will save time by not having to re-test the same
wires over again.
ADDITIONAL PARTS
, which are not included with this unit, may be needed for your particular vehicle. . These items may
include extra relays (Part#CS-402A), General Motors Anti-Theft System Bypass modules for Vats / Passkey® / Passlock®
Systems, (Part# CS-GMATA II) or Transponder Anti-Theft Adapter modules (Part # CS-TATA).
TECHNICAL SUPPORT: 1-800-998-6880
Monday - Friday 8:00am - 4:30pm Pacific Time
Web Site: www.crimestopper.com
E-mail: [email protected]
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV A 09.10.01
This device complies with FCC Rules part 15. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference that
may be received, including interference that may cause undesired
operation. The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modification could void the user’s authority to use the
equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATION CAUTIONS & WARNINGS **FOR SAFETY REASONS, DO NOT INSTALL THE RS800 Series II in vehicles with MANUAL TRANSMISSIONS .** If accidentally left in gear, a remote started vehicle could become a self-propelled threat to life and property. WARNING: This system does NOT have engine over-rev...
IGNITION SWITCH WIRING 6 PIN HIGH-CURRENT CONNECTORS: PIN 1: BROWN 14 GA.: STARTER OUTPUT (30A) PIN 2: GRAY 14 GA.: ACCESSORY / IGNITION 2 (30A) PIN 3: RED 14 GA.: BATTERY CONSTANT FUSED (30A) PIN 4: RED 14 GA.: BATTERY CONSTANT FUSED (30A) PIN 5: PINK 14 GA.: IGNITION 1 (30A) PIN 6: WHITE 18 GA.: (...
POWER DOOR LOCK WIRING 3 PIN DOOR LOCK PLUG: PIN 1: GREEN: (-) Negative pulse for LOCK PIN 2: RED: +12V Coil Power for external relays TERM 86. PIN 3: BLUE: (-) Negative pulse for UNLOCK DETERMINING DOOR LOCK TYPE: We recommend determining the type of locking system the vehicle has before connecting...
