Crimestopper CS-2011RS - Manual
Crimestopper CS-2011RS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; OPERATION CAUTIONS & WARNINGS; and its
- Page 3 – OPERATING INSTRUCTIONS - ALARM; Alarm Triggering
- Page 4 – Prior intrusion Alert
- Page 5 – Valet Mode (Enter manually or using the remote)
- Page 6 – Shock Sensor = 1 Flash; REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START; be turned off with remote transmitter.
- Page 7 – REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:; IGN; REMOTE ENGINE STARTING - UNSUCCESSFUL START; time. For hard starting engines, the unit will allow a starter crank; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:
- Page 8 – ENTERING YOUR REMOTE STARTED VEHICLE:; is now controlling your vehicle.; ENTERING A VEHICLE DURING “IDLE-DOWN” or “INFINITY RUN” MODES:; See “ENTERING YOUR REMOTE STARTED VEHICLE” section above.
- Page 9 – INFINITY RUN MODE; This mode allows the vehicle’s engine to remain running; INFINITY RUN MODE – EXITING THE VEHICLE:; FLASH FOR PROGRAMMED; See “ENTERING YOUR REMOTE STARTED VEHICLE” section at top of page 8.
- Page 10 – TIMED SELF START MODE; confirmation that the unit is in Timed Self-Start Mode.; PRESS 1X; RESETTING TIMED SELF START MODE
- Page 11 – OPTIONAL TURBO TIMER MODE; OPTIONAL TURBO TIMER MODE:; should remain running for the selected number of minutes.; REMOVE KEY
- Page 12 – ANTI CARJACK PROTECTION; REMOTE OPERATED CARJACK PROTECTION
- Page 13 – TRANSMITTER PROGRAMMING; learn. Now the unit is waiting for a 2; code, so repeat this step as needed with up to 3 additional remotes.; code, 3 flashes for the 3; mode, otherwise turn key OFF and close the hood.; WAIT FOR
- Page 14 – VEHICLE OPERATION; Your remote may have a push-button on the side in place of a slide-; II
- Page 15 – TROUBLESHOOTING: “BEFORE YOU CALL SECTION”; SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS:
CS-2011RS Series IV
Super Rage™
Remote Control Alarm & Remote Engine Starting System
OPERATION INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of a Super Rage
™ Alarm & Remote Engine Starter by Crimestopper
Security Products Inc.
This booklet contains the information necessary for operating your system. If any
questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Power,
Ground, Lights, Siren, etc.
-OPTIONAL:
Optional features are connected only if desired or agreed upon by the installing dealer i.e. Door
Locks, Horn Honk, Dome light illumination, Starter Kill, L.E.D., Trunk Pop, etc. These features may require
additional parts and labor charges. Consult with your installer about these features
before
installation.
CONTACT INFORMATION:
This device complies with FCC Rules part 15. Operation is subject
to the following two conditions: 1) This device may not cause
interference, and (2) this device must accept any interference that
may be received, including interference that may cause undesired
operation. The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modification to this
equipment. Such modification could void the user's authority to
operate the equipment.
TECHNICAL SUPPORT (800)-998-6880
Monday - Friday 8:00am - 4:30pm Pacific
Website: www.crimestopper.com
E-mail: [email protected]
CRIMESTOPPER
SECURITY PRODUCTS, INC.
1770 S. TAPO STREET
SIMI VALLEY, CA. 93063
REV. A 9.2003
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS Operation Cautions & Warnings……..………..…………………………………………………………….………2 Operating Instructions - Alarm……………………………………………………….………..……………..……..3-6 LED Diagnostics………………..…………………………………………………………………….………..…..….6 Remote Engine Control………………………...…………………………………………………….………...…..6-10 Optional ...
OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The System will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. Aft...
OPERATING INSTRUCTIONS - ALARM Prior intrusion Alert This system will notify you if the alarm was tripped while you where away. Upon disarming, the two normal disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any signs of a break in or tampering....
