Crimestopper CS-2011RS - Manuals

Page 2 - TABLE OF CONTENTS; OPERATION CAUTIONS & WARNINGS; and its

TABLE OF CONTENTS Operation Cautions & Warnings……..………..…………………………………………………………….………2 Operating Instructions - Alarm……………………………………………………….………..……………..……..3-6 LED Diagnostics………………..…………………………………………………………………….………..…..….6 Remote Engine Control………………………...…………………………………………………….………...…..6-10 Optional ...

Page 3 - OPERATING INSTRUCTIONS - ALARM; Alarm Triggering

OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The System will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. Aft...

Page 4 - Prior intrusion Alert

OPERATING INSTRUCTIONS - ALARM Prior intrusion Alert This system will notify you if the alarm was tripped while you where away. Upon disarming, the two normal disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any signs of a break in or tampering....

Page 5 - Valet Mode (Enter manually or using the remote)

OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to activate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a mome...

Page 6 - Shock Sensor = 1 Flash; REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START; be turned off with remote transmitter.

OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment s...

Page 7 - REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:; IGN; REMOTE ENGINE STARTING - UNSUCCESSFUL START; time. For hard starting engines, the unit will allow a starter crank; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: AFTER IGN 3 STARTER THEN FLASH 1X SOLID SOLID SEC. S TART REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to r...

Page 8 - ENTERING YOUR REMOTE STARTED VEHICLE:; is now controlling your vehicle.; ENTERING A VEHICLE DURING “IDLE-DOWN” or “INFINITY RUN” MODES:; See “ENTERING YOUR REMOTE STARTED VEHICLE” section above.

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the ...

Page 9 - INFINITY RUN MODE; This mode allows the vehicle’s engine to remain running; INFINITY RUN MODE – EXITING THE VEHICLE:; FLASH FOR PROGRAMMED; See “ENTERING YOUR REMOTE STARTED VEHICLE” section at top of page 8.

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Fo...

Page 10 - TIMED SELF START MODE; confirmation that the unit is in Timed Self-Start Mode.; PRESS 1X; RESETTING TIMED SELF START MODE

REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILAT...

Page 11 - OPTIONAL TURBO TIMER MODE; OPTIONAL TURBO TIMER MODE:; should remain running for the selected number of minutes.; REMOVE KEY

OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep yo...

Page 12 - ANTI CARJACK PROTECTION; REMOTE OPERATED CARJACK PROTECTION

ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds. The parking lights will flash 2 times and the LED ...

Page 13 - TRANSMITTER PROGRAMMING; learn. Now the unit is waiting for a 2; code, so repeat this step as needed with up to 3 additional remotes.; code, 3 flashes for the 3; mode, otherwise turn key OFF and close the hood.; WAIT FOR

TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming!! This system allow storage of up to 4 different remote codes in memory. 1. Open hood (ground the...

Page 14 - VEHICLE OPERATION; Your remote may have a push-button on the side in place of a slide-; II

2 VEHICLE OPERATION The CS-2011RS Series IV system can be used for 2 car operation. A single remote can control two independent vehicles with an identical systems installed. See diagram below on how to switch your remote to car 2 operation. Follow the “Transmitter Programming” steps on the second ve...

Page 15 - TROUBLESHOOTING: “BEFORE YOU CALL SECTION”; SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS:

TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS: This is normal operation. There may be a slight flicker visible from the LED w...