Crimestopper CS-2003DC - Manual

Crimestopper CS-2003DC

Crimestopper CS-2003DC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; CONTROL MODULE MOUNTING; Driver’s Side underdash
  • Page 3 – COMPONENT MOUNTING; LED; WIRING; PIN 1: GRAY WIRE: INPUT SOURCE FOR REMOTE OUTPUT 1 RELAY
  • Page 4 – PIN 11: YELLOW WIRE: IGNITION SWITCHED “ON” and “START” +12 VOLTS
  • Page 5 – The Sensor supplied with the system does not require; BLACK WIRE SENSOR GROUND; POWER DOOR LOCK WIRING; Aftermarket systems.; DETERMINING DOOR LOCK TYPE:; Many GM Some Chrysler; One wire dual voltage:; Some Nissan Subaru; Electric vacuum pump:
  • Page 7 – SEPARATE DRIVER’S DOOR UNLOCK WIRING; NEGATIVE TRIGGER DOOR LOCKS
  • Page 8 – TRANSMITTER PROGRAMMING; Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3; THIS
  • Page 9 – OPTION PROGRAMMING; CS-2003DC PROGRAMMABLE OPTIONS; PROGRAMMING OPTIONS CHART
  • Page 10 – PARKING LIGHTS ON WITH DISARM; Doors will not lock if they are open to prevent locking the keys in; DOUBLE UNLOCK PULSE
  • Page 11 – ACTIVE or PASSIVE CARJACK PROTECTION; OPERATION; BUTTON REMOTE TRANSMITTER:; ACTIVE ARMING
  • Page 13 – SOFT CHIRP ARM/DISARM; SILENT ARM/DISARM MODE; Doors
  • Page 14 – VEHICLE CONTROL; CARJACK PROTECTION; ACTIVE CARJACK
Loading the manual






CS-2003DC

REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS

INTRODUCTION

CONGRATULATIONS

on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security

Products Inc. This system features DYNAMIC CODE anti code-grabbing technology. The remote control
code changes with every use of the transmitter making it impossible to scan or record the codes for use later
on. This booklet contains the information necessary for installing, using, and maintaining your alarm system.
If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech
Support number below.

*IMPORTANT INFORMATION: Primary and Optional Features

-PRIMARY:

These are features that must be connected in order for the system to operate properly i.e. Siren,

L.E.D., Power, Ground, Doorpin, etc.

-OPTIONAL:

These are features to be connected only if desired or agreed upon by the installing dealer (i.e.

Door Locks, Flashing Lights, Starter Kill, Hood, Trunk, and Auxiliary Remote Outputs etc.)

TECH SUPPORT

Mon-Fri 8:00 AM-4:30 PM Pacific Time

(800) 998-6880


This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; CONTROL MODULE MOUNTING; Driver’s Side underdash

INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUS...

Page 3 - COMPONENT MOUNTING; LED; WIRING; PIN 1: GRAY WIRE: INPUT SOURCE FOR REMOTE OUTPUT 1 RELAY

COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible lo...

Page 4 - PIN 11: YELLOW WIRE: IGNITION SWITCHED “ON” and “START” +12 VOLTS

WIRING PIN 8: BLACK WIRE: CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. We recommend the kick panel area for your ground point. PIN 9: WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (Optional) Connect to swi...

Other Crimestopper Models

All Crimestopper Other