Crimestopper CS-2003DC - Manuals

Page 2 - INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; CONTROL MODULE MOUNTING; Driver’s Side underdash

INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUS...

Page 3 - COMPONENT MOUNTING; LED; WIRING; PIN 1: GRAY WIRE: INPUT SOURCE FOR REMOTE OUTPUT 1 RELAY

COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible lo...

Page 4 - PIN 11: YELLOW WIRE: IGNITION SWITCHED “ON” and “START” +12 VOLTS

WIRING PIN 8: BLACK WIRE: CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. We recommend the kick panel area for your ground point. PIN 9: WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (Optional) Connect to swi...

Page 5 - The Sensor supplied with the system does not require; BLACK WIRE SENSOR GROUND; POWER DOOR LOCK WIRING; Aftermarket systems.; DETERMINING DOOR LOCK TYPE:; Many GM Some Chrysler; One wire dual voltage:; Some Nissan Subaru; Electric vacuum pump:

WIRING 4-PIN SENSOR PLUG: WHITE WIRE: NEG. WARN AWAY * The Sensor supplied with the system does not require BLUE WIRE: NEG. TRIGGER any additional wiring, simply mount the sensor in a BLACK WIRE SENSOR GROUND suitable location, plug in, and adjust sensitivity. RED WIRE SENSOR +12V POWER 3-PIN PASSEN...

Page 7 - SEPARATE DRIVER’S DOOR UNLOCK WIRING; NEGATIVE TRIGGER DOOR LOCKS

SEPARATE DRIVER’S DOOR UNLOCK WIRING NEGATIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHITE GREEN BLUE BROWN VIOLET + 86 85 87 30 87A POSITIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + ...

Page 8 - TRANSMITTER PROGRAMMING; Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3; THIS

TRANSMITTER PROGRAMMING 1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 rd time. (ON/OFF, ON/OFF, ON) You should hear (3) chirps. 2. Push and release the Program/Override Button 5 times and the Status LED will come on solid. 3. Press #1 (LOCK) on new transmitter two times. LED goes ...

Page 9 - OPTION PROGRAMMING; CS-2003DC PROGRAMMABLE OPTIONS; PROGRAMMING OPTIONS CHART

OPTION PROGRAMMING CS-2003DC PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps. 2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to the feature list below. Th...

Page 10 - PARKING LIGHTS ON WITH DISARM; Doors will not lock if they are open to prevent locking the keys in; DOUBLE UNLOCK PULSE

OPTION PROGRAMMING 2. SOFT CHIRP ARM / DISARM WITH BUTTON #3 (SHORT PRESS) With this feature, the system can be programmed to Arm and Disarm with a very soft siren chirp using a short press on button #3 on the remote. The Factory Default setting is ON. 3. PARKING LIGHTS ON WITH DISARM Keeps parking ...

Page 11 - ACTIVE or PASSIVE CARJACK PROTECTION; OPERATION; BUTTON REMOTE TRANSMITTER:; ACTIVE ARMING

OPTION PROGRAMMING 12. ACTIVE or PASSIVE CARJACK PROTECTION This feature controls the alarm system’s Carjack Mode for ACTIVE OR PASSIVE protection. Option number 9 Must be enabled to allow Carjack functions to operate. See Operation section for Carjack Features. Factory default is Active. 13. 10/60 ...

Page 13 - SOFT CHIRP ARM/DISARM; SILENT ARM/DISARM MODE; Doors

OPERATION SOFT CHIRP ARM/DISARM This system can be armed and disarmed with very faint/soft chirps as needed. Press and quickly release Button #3 (Trunk pop) to Arm and Disarm system with soft chirps. Note: If Button #3 is pressed too long, then the Aux. 1 output will activate. SILENT ARM/DISARM MODE...

Page 14 - VEHICLE CONTROL; CARJACK PROTECTION; ACTIVE CARJACK

OPERATION 2 nd AUX. OUTPUT (REMOTE AUX. OUTPUT 2) To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (1) second. This output can be used to control other optional add-on accessories such as Remote Engine Start Modules, Window Roll up/down modules, etc. 2 VEHICLE CO...