Crimestopper CS-2000 - Manual
Crimestopper CS-2000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; remove vehicle dome light fuse while working on the vehicle.; DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED; column, or any other moving parts in the vehicle.; COMPONENT MOUNTING; Mount the red; LED; firewall or side paneling.
- Page 3 – WIRING; Connect to RED siren wire.
- Page 4 – YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS; Scrape away any paint or dirt from; BLACK WIRE: SENSOR GROUND; PROGRAMMING; PROGRAMMABLE OPTIONS; the feature list below. The siren will chirp for each button press.; Option # Description
- Page 5 – SILENT ARMING /DISARMING; Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3; The system is now in programming mode.; OPERATION; ACTIVE ARMING
- Page 6 – REMOTE PANIC PROTECTION; Note: This unit does not include a Passive Door Lock feature.; PRIOR INTRUSION ALERT
- Page 7 – POWER DOOR LOCK WIRING
CS-2000
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of a
™ Remote Alarm System by Crimestopper Security Products Inc.
This booklet contains the information necessary for installing, using, and maintaining your alarm system. If
any questions arise, contact your installation dealer first, or Crimestopper Security Products Inc. at the Tech
Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Siren,
L.E.D., Power, Ground, Doorpin, etc.
-OPTIONAL:
These are features to be connected only if desired or agreed upon by the installing dealer (i.e.
Door Locks, Starter Kill, Hood, Trunk, and Auxiliary Remote Output etc.)
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
www.crimestopper.com
[email protected]
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUS...
WIRING RED WIRE: +12V POWER INPUT (15 Amp fuse) Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle battery positive terminal. WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (10 Amp Max.) Connect to switched parking light wire at bac...
WIRING YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start” positions. BLACK WIRE: SYSTEM CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any ...
