Page 2 - TABLE OF CONTENTS
INST ALLA TION MANUAL TABLE OF CONTENTS 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6 Cleaning and Maintenance . . . . . . . . . . . . . . . . . . 7 MotorGrease Filter(s)Non-Ducted Recirculatio...
Page 3 - SAFETY; READ AND SAVE THESE INSTRUCTIONS; INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.; WARNING
INSTALLATION MANUAL SAFETY 3 READ AND SAVE THESE INSTRUCTIONS ! Intended for domestic cooking only ! INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. In U.S.A., register your range hood online at www.broan.com In Canada, register your range hood online at www.broan.ca ! WARNING TO REDUCE THE RISK OF FIR...
Page 4 - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:; CAUTION
INST ALLA TION MANUAL SAFETY 4 ! WARNING TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. b) Always turn hood ON when cooking at high hea...
Page 5 - Operation; Operate the hood as follows:; BKDEG1 SERIES; FILTER CLEANING REMINDER; short lapse of time, and then resume to LOW speed.; LIGHT BUTTON
INSTALLATION MANUAL OPERA TION 5 Operation Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and fresher. Operate the hood as fol...
Page 6 - OPERA; BLOWER SWITCH
INST ALLA TION MANUAL OPERA TION 6 BLOWER SWITCH I Turns blower on to LOW speed. • Turns blower OFF. II Turns blower on to HIGH speed. LIGHT SWITCH I Turns light on in LOW intensity. • Turns light OFF. II Turns light on to HIGH intensity. BKSA1 SERIES LIGHT SWITCH Turns light OFF. I Turns light on...
Page 7 - CLEANING AND MAINTENANCE; Cleaning and Maintenance; MOTOR; Avoid when choosing a detergent:; bleach; PAINTED FINISH CLEANING:
INSTALLATION MANUAL CLEANING AND MAINTENANCE 7 Cleaning and Maintenance Proper maintenance of the Range Hood will assure proper performance of the unit. MOTOR The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or unusual noise, replace the motor with the...
Page 8 - INST; Install Ductwork (Ducted Installations Only)
INST ALLA TION MANUAL INST ALLA TION 8 Recommended Tools and Accessoriesfor Installation • Measuring tape • Phillips screwdriver no. 2 • Flat blade screwdriver (to open knockout holes) • Drill, 1/8” drill bit and 1½” hole saw (to mark holes for ducting and cut electrical access hole) • 7/64” drill b...
Page 9 - TION; Contents; Make sure that the following items are included:; Maximum Duct Lengths Recommended; * Standard elbows with 1” internal radius.
INSTALLATION MANUAL INSTALLA TION 9 Contents Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer. Make sure that the following items are included: BKDB1 Series BKDEG1 Series (1) 3¼” X 10” D AMPER ASSEMBLY * (1) 7” R OUND D U...
Page 10 - BKSH1 Series; BKSA1 Series
INST ALLA TION MANUAL INST ALLA TION 10 BKSH1 Series (2) G REASE F ILTERS (1) 3¼” X 10” D AMPER ASSEMBLY * (1) 7” R OUND D UCT C ONNECTOR (1) P ARTS B AG *** C ONTAINING : * F IND INSIDE OF HOOD *** F IND PARTS BAG BEHIND THE DAMPER ASSEMBLY INSIDE OF HOOD (2) I NSTALLATION B RACKETS ** FOR FRAMED C...
Page 11 - Prepare the Hood; and; illustrations may sligthly differ from your unit.
INSTALLATION MANUAL INSTALLA TION 11 Prepare the Hood 1 ] If present, remove all protective polyfilm from the hood and/or parts. 2 ] Using the finger cup or tab, remove the grease filters from the hood by pushing down and tilting filter out . 3 ] Remove the EZ1 brackets from inside the hood by c...
Page 12 - NON-DUCTED INSTALLATION ONLY
INST ALLA TION MANUAL INST ALLA TION 12 5 ] Remove 7” Round Duct Plate from top/back of hood (see illustration below). RECIRCULATION COVER PLATE SCREWS 6 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal exhaust) of hood. Install an appropriate strain relief, 1...
Page 13 - DUCTED INSTALLATION ONLY; TIP; connection with the house duct work.
INSTALLATION MANUAL INSTALLA TION 13 DUCTED INSTALLATION ONLY TIP : Inser t a small length of duct over the 3¼” x 10” damper assembly (for rectangular ducting) or 7” round (for round ducting) and seal the joint using aluminum foil duct tape to ease connection with the house duct work. 8 ] Remove 3¼”...
Page 14 - Prepare the Hood Location; EZ1 one-person installation system; If replacing a hood and plan to use; Measure and mark the hood center line on cabinet bottom.
INST ALLA TION MANUAL INST ALLA TION 14 Prepare the Hood Location NOTE: Before star ting installation, read all the steps of these instructions.Use the illustration below to identify your kitchen cabinet type. EZ1 one-person installation system EZ1 installation is designed for use with kitchen cabin...
Page 15 - location on template.
INSTALLATION MANUAL INSTALLA TION 15 FRAMED CABINET 7/64” X Y Z Refer to the marking on the brackets to determine the correct installation side and orientation. Mate the corresponding bracket to the cabinet side frame, while placing rear end of bracket against the wall. Use a pencil to mark 3 hol...
Page 16 - Use a pencil to mark 3 holes.
INST ALLA TION MANUAL INST ALLA TION 16 [ \ 7/64” X 3 X Y Z Refer to the marking on brackets to determine the correct installation side and orientation. Align the corresponding bracket to the cabinet side, while placing rear end of bracket against the wall. Draw a line on the outer edge of the br...
Page 17 - While holding the hood
INSTALLATION MANUAL INSTALLA TION 17 A B D C Install the Hood (EZ1 Bracket) 1 ] Run house power cable between service panel and hood location. 2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B , on front C and D on illustration below); these holes allow th...
Page 18 - ] For framed cabinet; , secure the hood to the cabinet using 4 no. 8 x 5/8” round head wood
INST ALLA TION MANUAL INST ALLA TION 18 7 ] For framed cabinet , secure the hood to the EZ1 brackets using 4 no. 8-18 x 1/2” metal screws with washers (screws and washers included in parts bag). Insert 2 screws and washers per side, in the slots (as shown in inset on illustration below). 8 ] For fra...
Page 19 - Standard Installation (without EZ1 brackets)
INSTALLATION MANUAL INSTALLA TION 19 Standard Installation (without EZ1 brackets) 1 ] Use the proper diagram below for placement of duct work and electrical cutout in cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole, only cut the hole for electrical wiring. 2 ] Install p...
Page 21 - Connect the Wiring
INSTALLATION MANUAL INSTALLA TION 21 Connect the Wiring 1 ] Connect House Power Cable to range hood wiring: BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. ! WARNING Risk of electric shock. Electrical wiring must be done by qualifi ed personnel in accordance with all ...
Page 22 - Gently push upwards and turn clockwise until secure.; Ducted Installation Only:
INST ALLA TION MANUAL INST ALLA TION 22 Light Bulbs (BKSA1 and BKSH1 Series only) 1 ] Align the bulb leads with the small indentations located on the border of the lamp location on hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in the socket. 2 ] Gently p...
Page 23 - WIRING DIAGRAMS; ontr; BKDB1 SERIES
INSTALLATION MANUAL WIRING DIAGRAMS 23 12 3 4 5 6 1 2 3 4 J6 Ov err ide J4 LED J1 0 Interf ace 1 2 3 4 5 6 7 8 User int erf ace mount ed to J1 0 on bac k of contr ol boar d. J1 T ransf ormer J2 P o wer , Motor 5 4 3 2 1 5 4 3 2 1 6 7 C ontr ol Boar d R R BL BL BK W BK BK W G/Y R (Lo w) O (Medium) BK...
Page 25 - BKSH1 SERIES
INSTALLATION MANUAL WIRING DIAGRAMS 25 G/Y W BK O R F AN MO T OR BN BN/W G/Y R (Lo w) BK (High) W 120 V A C Line Neutr al Gr ound BK BK Mot or S witch Light S witch Y (Lo w) BL (High) W W BK BK COLOR CODE BK BL BN BLACK BLUE BROWN R W Y RED WHITE YELLOW BN/W G/Y O BROWN/WHITE GREEN/YELLOW ORANGE W 1...
Page 26 - SERVICE P
INST ALLA TION MANUAL SERVICE P AR TS 26 K EY NO . P ART NO . D ESCRIPTION Q UANTITY 30" B LACK 30" S TAINLESS 30" W HITE 36" B LACK 36" S TAINLESS 36" W HITE 1 S97020029 R ECIRCULATION COVER PLATE , B LACK ( INCLUDING SCREWS ) 1 1 S97020030 R ECIRCULATION COVER PLATE , W HIT...
Page 29 - BKSA1 SERIES
INSTALLATION MANUAL SERVICE P AR TS 29 K EY NO . P ART NO . D ESCRIPTION Q UANTITY 30" S TAINLESS 30" W HITE 30" B LACK 1 S97020029 R ECIRCULATION COVER PLATE , B LACK ( INCLUDING SCREWS ) 1 S97020030 R ECIRCULATION COVER PLATE , W HITE ( INCLUDING SCREWS ) 1 S97020031 R ECIRCULATION COV...
Page 30 - ARRANTY
INST ALLA TION MANUAL W ARRANTY 30 Limited Warranty Warranty Period and Exclusions: Broan-NuTone LLC and Broan-NuTone Canada ULC (either being the “Company”) warrants to the original consumer purchaser of its product (“you”) that the product (the “Product”) will be free from material defects in the ...
