Broan-NuTone BCSQ130SS - Manuals

Broan-NuTone BCSQ130SS Range Hood – User Manual in PDF format online.

Manuals:

User Manual

User Manual Broan-NuTone BCSQ130SS

Summary

Page 2 - TABLE OF CONTENTS

INST ALLA TION MANUAL TABLE OF CONTENTS 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Cleaning and Maintenance . . . . . . . . . . . . . . . . . 6 MotorGrease FilterNon-Ducted Recirculation Fil...

Page 3 - SAFETY; READ AND SAVE THESE INSTRUCTIONS; INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.; WARNING

INSTALLATION MANUAL SAFETY 3 READ AND SAVE THESE INSTRUCTIONS ! Intended for domestic cooking only ! INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. Register your range hood online at www.broan.com ! WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: • Use ...

Page 4 - CAUTION

INST ALLA TION MANUAL SAFETY 4 ! WARNING TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. b) Always turn hood ON when cooking at high hea...

Page 5 - Operation; II; CCSP1 SERIES

INSTALLATION MANUAL OPERA TION 5 Operation Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and fresher. Operate the hood as fol...

Page 6 - CLEANING AND MAINTENANCE; Cleaning and Maintenance; Avoid when choosing a detergent:

INST ALLA TION MANUAL CLEANING AND MAINTENANCE 6 Cleaning and Maintenance Proper maintenance of the Range Hood will assure proper performance of the unit. MOTOR The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or unusual noise, replace the motor with t...

Page 7 - TION; Install Ductwork (Ducted Installations Only)

INSTALLATION MANUAL INSTALLA TION 7 Recommended Tools and Accessoriesfor Installation • Measuring tape • Phillips screwdriver no. 2 • Flat blade screwdriver (to open knockout holes) • Drill, 1/8” drill bit and 1½” hole saw (to mark holes for ducting and cut electrical access hole) • Wood shims (2) a...

Page 8 - INST; Contents

INST ALLA TION MANUAL INST ALLA TION 8 Contents Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer. Make sure that the following items are included: BCSQ1 Series and CCSP1 Series (2) G REASE F ILTERS (1) P ARTS B AG ** C ON...

Page 9 - Prepare the Hood

INSTALLATION MANUAL INSTALLA TION 9 Prepare the Hood 1 ] If present, remove all protective polyfilm from the hood and/or parts. 2 ] Using the tab, remove the grease filters from the hood by pushing down and tilting filters out. 3 ] Remove both screws holding damper assembly to hood. Remove parts bag...

Page 10 - NON-DUCTED INSTALLATION ONLY

INST ALLA TION MANUAL INST ALLA TION 10 5 ] Remove 7” Round Duct Plate from top/back of hood (see illustration below). RECIRCULATION COVER PLATE SCREWS 1 ] Remove Electrical Power Cable Knockout from top (vertical wiring) or back (horizontal wring) of hood. Install an appropriate strain relief, 1/2”...

Page 11 - DUCTED INSTALLATION ONLY

INSTALLATION MANUAL INSTALLA TION 11 DUCTED INSTALLATION ONLY TIP : Inser t a small length of duct over the 3¼” x 10” damper assembly (for rectangular ducting) or 7” round (for round ducting) and seal the joint using aluminum foil duct tape to ease connection with the house duct work. 8 ] Remove 3¼”...

Page 12 - Prepare the Hood Location

INST ALLA TION MANUAL INST ALLA TION 12 Prepare the Hood Location 1 ] Use the proper diagram below for placement of duct work and electrical cutout in cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole, only cut the hole for electrical wiring. 2 ] Install par t-way four (4...

Page 13 - Install the Hood

INSTALLATION MANUAL INSTALLA TION 13 Install the Hood 1 ] Run house power cable between service panel and hood location. Run the house power cable into the hood through the strain relief previously installed in step 6 on page 10. 2 ] Hang hood from (4) mounting screws previously installed. Slide hoo...

Page 14 - Connect the Wiring; Install the Filters

INST ALLA TION MANUAL INST ALLA TION 14 Connect the Wiring 1 ] Connect House Power Cable to range hood wiring: BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. ! WARNING Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with al...

Page 15 - WIRING DIAGRAMS; BCSQ1 SERIES

INSTALLATION MANUAL WIRING DIAGRAMS 15 COLOR CODE BK BLBNBN/W BLACKBLUEBROWNBROWN/WHITE G/YORW GREEN/YELLOWORANGEREDWHITE 1 20 V A C Line Neutral Ground 12 3 4 5 6 1 2 3 4 5 6 G/Y G/Y W W W W BK (High) BK O (Medium) BK O R (Low) R FAN MOTOR BN/W BN BL Motor On/Off Motor Speeds Lights On/Off 1 2 3 W ...

Page 16 - SERVICE P

INST ALLA TION MANUAL SERVICE P AR TS 16 R EPLACEMENT P ARTS AND R EPAIRS In order to ensure your unit remains in good working condition, you must use Broan-NuTone LLC genuine replacement parts only. Broan-NuTone LLC genuine replacement parts are specially designed for each unit and are manufactured...

Page 18 - ARRANTY

INST ALLA TION MANUAL W ARRANTY 18 Limited Warranty Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original consumer purchaser of its product (“you”) that the product (the “Product”) will be free from material defects in the Product or its workmanship for a period o...